That was Mike Pung's work.
http://ornamentalmills.com/turningaround/Pugn4.htm
- Original Message -
From: Bill Bulkeley
To: legacy-ornamental-mills@googlegroups.com
Sent: Tuesday, September 25, 2012 10:03 PM
Subject: Re: Trimming the outside of a bowl
that one i
: legacy-ornamental-mills@googlegroups.com
Sent: Wednesday, September 26, 2012 11:45 AM
Subject: Re: Trimming the outside of a bowl
Bill
Did you make or buy the universal joint ?
Harvey
On Tue, Sep 25, 2012 at 8:30 PM, curt george wrote:
Now that's pretty neat! I hav
to:legacy-ornamental-mills@googlegroups.com>
*Sent:* Wednesday, September 26, 2012 10:49 AM
*Subject:* Re: Trimming the outside of a bowl
Hello Harvey
I have also tried that, My Legacy will only get to 48 deg. It
wasn't enough for what I was doing, Depending on how long your
s something to think about though? ;-)
> Have a good night.
> C.A.G.
>
> - Original Message -
> *From:* Harvey Matyas
> *To:* legacy-ornamental-mills@googlegroups.com
> *Sent:* Tuesday, September 25, 2012 9:09 PM
> *Subject:* Re: Trimming the outside of a bowl
>
ental-mills@googlegroups.com
Sent: Tuesday, September 25, 2012 9:09 PM
Subject: Re: Trimming the outside of a bowl
I believe this is his improved video
http://www.youtube.com/watch?v=ZWVa3qYrAtI
Harvey
On Tue, Sep 25, 2012 at 7:49 PM, curt george wrote:
Hello Harvey
I have
: Trimming the outside of a bowl
if you mount a universal joint in your headstock it will allow you to get
much greater tapers on your mill
because you lower the rails strait instead of only one end there is a pic
some where of this
that would take care of the out side
Bill
To: legacy-ornamental-mills@googlegroups.com
Sent: Wednesday, September 26, 2012 10:49 AM
Subject: Re: Trimming the outside of a bowl
Hello Harvey
I have also tried that, My Legacy will only get to 48 deg. It wasn't enough
for what I was doing, Depending on how long your Lega
ures when its done.
> C.A.G.
>
> - Original Message -
> *From:* Harvey Matyas
> *To:* legacy-ornamental-mills@googlegroups.com
> *Sent:* Tuesday, September 25, 2012 7:31 PM
> *Subject:* Trimming the outside of a bowl
>
> I'm using a RingMaster to cut rings fo
to see it. that sounds like a pretty Cool
jig.
Good luck on the project.Please post pictures when its done.
C.A.G.
- Original Message -
From: Harvey Matyas
To: legacy-ornamental-mills@googlegroups.com
Sent: Tuesday, September 25, 2012 7:31 PM
Subject: Trimming the outside of a bo
I'm using a RingMaster to cut rings for a bowl. After I glue up the rings
they need to be sanded or? What I was wondering is it the Legacy can have
a bowl mounted to it qo that the router can cut the bowl smooth on the
outside.I know that if I had a straight column it would work but the
bowl
10 matches
Mail list logo