Tell her you were defending her honor --
On 12/29/05, Hans Neureiter <[EMAIL PROTECTED]> wrote:
> Keep your hands in your pockets and tell her "you should see the other guy".
--
OK Don, KD5NRO
Norman, OK
'90 300D, '87 300SDL, '81 240D, '78 450SLC
The FSM created the Diesel Benz
http://www.venga
Keep your hands in your pockets and tell her "you should see the other guy".
But don't it feel so good when it finally *THUNKS*.
On 12/29/05, tom savage <[EMAIL PROTECTED]> wrote:
>
> Well I did it. Further pushing and pulling on the pumpkin yielded no
> new results. Tried to undo the big nut o
tom savage wrote:
Put everything back together and I'm good to go. Go where? I've got a
date in an hour and a black eye and "not with those hands" hands. But
at least my car works :)
Chicks dig scars. Not sure about black eyes, though.
--
John L. Ervine
1981 240D 4-spd 268+kmi
1980 300TD
Well I did it. Further pushing and pulling on the pumpkin yielded no
new results. Tried to undo the big nut on the driveshaft, but it
wouldn't budge. Had no trouble getting it off a few years ago; must
have done a good job reinstalling it. So I unhooked the driveshaft at
the differential to
Russ Williams wrote:
It's one Big PITA to get them all stabbed into the subframe
again.
I just went thru this with my wife's 123 240D.
Thanks for the tips, guys; I'm glad to hear that I'm not the only one to
find this frustratingly difficult. I should note that with none of the
studs tighte
Tom,
Just loosen the rear stud nuts until they are almost off.
Then if you have a floor jack use it to jack up the diff. to
the subframe. Don't take off the nuts for the front studs while
doing this. It's one Big PITA to get them all stabbed into the subframe
again.
I just went thru this with my
Just a WAG - but if that doesn't do it, perhaps loosening the nut at
the driveshaft spline will help?
On 12/28/05, Tom Hargrave <[EMAIL PROTECTED]> wrote:
> Loosen the two rear studs and see of this gives you enough movement to push
> the front into place.
>
>
> Thanks,
> Tom Hargrave
> 256-656-19
: Mercedes mailing list
Subject: [MBZ] 123 - mating differential to subframe
Hello all,
I just finished replacing a rear trailing arm on my '82 300D, which was
quite an adventure. Along the way I (unnecessarily, it turned out)
separated the differential from the subframe. Now everything is
Hello all,
I just finished replacing a rear trailing arm on my '82 300D, which was
quite an adventure. Along the way I (unnecessarily, it turned out)
separated the differential from the subframe. Now everything is back
together, but the diff refuses to fully rejoin the subframe. The two
rea
