Hello,
I am trying to install software with drakx coming directly from the net,
i used to have this working with mandrake 9.0, but i can not remember
how i did that!!! Does somebody can tell me what is the ftp or http
address a need to put into the configuration media tab to have that
working.
hi,
my system:
processor athlon xp 1800
motherboard ECS K7S6A with SiS745 chipsets
memory 250Mb DDR
soundcard integrated to the motherboard sis7012 PCI
2 NIC realtek RTL8139
videocard sis315
router from british telecom (BT 5861 router) with NAT
JP
From: Greg Meyer [EMAIL PROTECTED]
Date:
i ran the mandrake wizard and i have now ip address 192.168.254.10 on eht0 and eht0 is
up. to test the card I ping 192.168.254.10 and it does reply correctly, then i plugged
it into a hub where i have an other machine with an ip address 192.168.254.17. Both
machine can't see each other, if i
yes on both numbers there is .localhost.localdomain localhost
From: et [EMAIL PROTECTED]
Date: 2003/02/18 Tue PM 03:19:43 GMT
To: [EMAIL PROTECTED]
Subject: Re: Re: [newbie] Ethernet Interface
does it have names after the numbers ?
On Tuesday 18 February 2003 10:11 am, [EMAIL
Ah maybe this is the problem, my network card is an 100Mps and my hub just 10Mps,
maybe the speed on the network card is not correct for the hub. But otherwise on the
back of the NIC the light is on and the hub as well.
JP
From: Derek Jennings [EMAIL PROTECTED]
Date: 2003/02/18 Tue PM
done that, still no response to ping from 192.168.254.17. To avoid problem with my hub
I used a crossover cable to plug directly both machine running 100Mps NICs.
I looked at the logs in logdrake and I get that:
NETDEV WATCHDOG: eth0: transmit timed out
eth0: Setting 100mbps full-duplex based on
I followed your instructions and the card is now set to 10Mps half duplex but i still
can't ping the other machine.
Thanks for the tool is good to know.
It's look like that nothing can go out or in from the networkcard. Am I doing
something really wrong on that card? Do you think I need to
Hi,
I am new to linux so I apologise in advance if this question has been asked before.
I am trying to connect my box to an ADSL router. Normally the router should assign an
IP address to my NIC as well as the gateway...by dhcp. When i run dhcpdc the router
doesn't assign the IP address,
