dear all,
i have an ACER travelmate 260 laptop i installed mandrake 8
i cannot install my modem
it shows an unknown device pctel and intel manifature
but mine is lucent softmodem ver 3.1.97
AC97 AMR intel MB
how to configure it
thanx
Want to buy your Pack or Services from MandrakeSoft?
Go to
On Thursday 16 October 2003 02:21 am, Wael Ahmed Ali wrote:
dear all,
i have an ACER travelmate 260 laptop i installed mandrake 8
i cannot install my modem
it shows an unknown device pctel and intel manifature
but mine is lucent softmodem ver 3.1.97
AC97 AMR intel MB
how to configure it
Mark Shaw wrote:
There aren't any jumpers of any kind on the card.
I think I've almost got this working. What I did was to
move the card from PCI slot 4 to slot 2, and reset the BIOS
to allow it to choose the IRQ. (The PnP-aware OS switch in
my BIOS is, and has always been, set to no.)
Hi Mark,
I just went down the road you're on,here's what I did. I have a zoom isa
modem. Of course you have disabled pnp in the bios,and I know you have the
jumpers on the card set to non-pnp as well. I put the modem on com 3( as set
by the jumpers on the modem). I have reserved irq 5
"Dave" == Puentes,David [EMAIL PROTECTED] writes:
Dave Can anyone recommend a source to refer to to install my
Dave modem on my linux system? I just don't know where to start
Dave and I am a fresh newbie.
What manufacturer and model modem?
--
Mike Fieschko, West Orange, NJ, USA
Can anyone recommend a source to refer to to install my modem on my linux
system? I just don't know where to start and I am a fresh newbie.
Thanks. Dave
Can anyone recommend a source to refer to to install my modem on my linux
system? I just don't know where to start and I am a fresh newbie.
Thanks. Dave
Peter Sadowski [EMAIL PROTECTED] wrote:
I bought US Robotics 56K PCI modem...
How can I configure it under Mandrake Linux 6.1
Is there a utility that I can use???
==
If this PCI Modem is a winmodem (as MOST PCI modems are), then you more than
likely will NOT be able to
No it's not a winmodem... I checked for that before I
bought it...
How is modem configuration done under Linux, and I
will try if it works...
Thanks
--- Michael Scottaline [EMAIL PROTECTED]
wrote:
Peter Sadowski [EMAIL PROTECTED] wrote:
I bought US Robotics 56K PCI modem...
How can I
Peter Sadowski [EMAIL PROTECTED] wrote:
No it's not a winmodem... I checked for that before I
bought it...
How is modem configuration done under Linux, and I
will try if it works...
Thanks
=
How did you check before purchasing? A couple of others on
Thanks, I will give it a try and let you guys know if
it works or not.
Peter
--- Michael Scottaline [EMAIL PROTECTED]
wrote:
Peter Sadowski [EMAIL PROTECTED] wrote:
No it's not a winmodem... I checked for that
before I
bought it...
How is modem configuration done under Linux, and I
I had the same problem. A winmodem. I had to buy one that worked with Linux.
Sorry, I felt much as you do.
From: Peter Sadowski [EMAIL PROTECTED]
Reply-To: [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Subject: Re: [[newbie] modem install ]
Date: Tue, 16 Nov 1999 04:47:05 -0800 (PST)
I just checked
I think all of their modems are serial modems. At least all of their
'consumer' modems.
mark
- Original Message -
From: Peter Sadowski [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Sent: Tuesday, November 16, 1999 9:20 AM
Subject: Re: [[newbie] modem install ]
Does USRobotics sell serial
To: [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Subject: [newbie] modem install
Date: Mon, 15 Nov 1999 19:17:12 -0800 (PST)
I bought US Robotics 56K PCI modem...
How can I configure it under Mandrake Linux 6.1
Is there a utility that I can use???
=
_
On Mon, 15 Nov 1999, you wrote:
I bought US Robotics 56K PCI modem...
How can I configure it under Mandrake Linux 6.1
Is there a utility that I can use???
The vast majority of PCI 56k modems are "WinModems" and as
such are unuseable under Linux. If you want to be
absolutely sure that your
On Tue, 16 Nov 1999, you wrote:
-Original Message-
From: Singer XJ Wang [SMTP:[EMAIL PROTECTED]]
Sent: â 16 ðåáîáø 1999 8:19
To: [EMAIL PROTECTED]
Subject:RE: [newbie] modem install
Confirmed WinModem
[Mike Perry] Anyone write software to emulate
On Tue, 16 Nov 1999, you wrote:
No it's not a winmodem... I checked for that before I
bought it...
How is modem configuration done under Linux, and I
will try if it works...
Peter:
Please visit the following page:
http://www.o2.net/~gromitkc/19991113a.html
Then, if it's listed as "OK"
On Tue, 16 Nov 1999, you wrote:
I just checked US Robotics site for my modem and in
fact it will work under DOS, so I assume that it
should work in Linux. I just don't know how to
configure it...
What's the exact model number of your modem?
John
that is
not a Winmodem, but am not sure on that one.
From: John Aldrich [EMAIL PROTECTED]
Reply-To: [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Subject: Re: [[newbie] modem install ]
Date: Tue, 16 Nov 1999 14:41:06 -0500
On Tue, 16 Nov 1999, you wrote:
Does USRobotics sell serial modems?
Not really
on that one.
From: John Aldrich [EMAIL PROTECTED]
Reply-To: [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Subject: Re: [[newbie] modem install ]
Date: Tue, 16 Nov 1999 14:41:06 -0500
On Tue, 16 Nov 1999, you wrote:
Does USRobotics sell serial modems?
Not really...US Robotics doesn't exist
I bought US Robotics 56K PCI modem...
How can I configure it under Mandrake Linux 6.1
Is there a utility that I can use???
=
__
Do You Yahoo!?
Bid and sell for free at http://auctions.yahoo.com
Check the supported hardware on linux-mandrake, but 99% of PCI modems are
winmodems.
- Original Message -
From: Peter Sadowski [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Sent: Monday, November 15, 1999 9:17 PM
Subject: [newbie] modem install
I bought US Robotics 56K PCI modem...
How can
WinModem
!Work
Sorry
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Peter Sadowski
Sent: Monday, November 15, 1999 11:17 PM
To: [EMAIL PROTECTED]
Subject: [newbie] modem install
I bought US Robotics 56K PCI modem...
How can I configure
Confirmed WinModem
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Lyndon Lininger Sr.
Sent: Monday, November 15, 1999 11:56 PM
To: [EMAIL PROTECTED]
Subject: Re: [newbie] modem install
Check the supported hardware on linux-mandrake, but 99
A few places.
either type 'modemconfig' or 'setup'
pj
Jerry Dean wrote:
Hello all
A question from an extreme linux newbie:
I had no problem installing Mandrake on my Pentium II 350 with 128 ram,
co existing with Win 98, I thought the intitial install was actually as
easy as
25 matches
Mail list logo
