For starters, try going through your BIOS and setting "Plug 'n Play OS" to
"no". This worked for my SMC PCI card, which uses the Realtek RTL8029 driver.
On Fri, 15 Dec 2000 03:12, Travis Mcbride wrote:
I am getting an eth0 initilization has failed error
message at bootup. Can anyone tell me
Did you install a dhcp client and set you card to get info thru dhcp?
If you haven't installed dhcpcd from the mandrake cd. then type
ifup eth0
This will bring up eth0 interface .
Sofian
Get a Free Linux Guestbook at http://www.iamnewbie.com
On Thursday 14 December 2000 18:40, you wrote:
There should not be any problem with the config of eth0. It might fail in
the initial stages for u may not have given the proper ip addrress etc.Pl
go to DRAKECONFIG and do the needful. Try giving the ip of 127.0.0.1 for
the loopback and 192.168.1.1 with netmask 255.255.255.0 Give ilt a local
I am getting an eth0 initilization has failed error
message at bootup. Can anyone tell me how to fix
this. The machine recognizes my ethernet card and I
know I have the right module setup.
Thanks Travis
__
Do You Yahoo!?
Yahoo! Shopping -
