Have you experimented with master/slave/cable-select settings on the
CDROM? Are you sure the MDK CD's are good? Check for bios updates
for the motherboard? Just some ideas, hope they help.
Sincerely,
Jim Hubbard
.--.
|o_o |
|:_/ |
// \ \
Hi Jim,
Thanks for the response. I do not have any of the
devices as slaves. I have 3 IDE devices - 2 HDDs and 1
CDROM/RW (Plextor 12/10/32). Apart from the 2 slots
for IDE on board I also have a PCI-IDE bridge for the
extra device. Here is my problem. The Mandrake Install
CD does not recognize
-
From: Nikunj Bansal [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, November 27, 2002 6:58 AM
To: [EMAIL PROTECTED]; [EMAIL PROTECTED]
Subject: RE: [newbie] ABIT BD-711 motherboard problems with Mandrake
Hi Jim,
Thanks for the response. I do not have any of the
devices as slaves. I have 3
Message-
From: Nikunj Bansal [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, November 27, 2002 6:58 AM
To: [EMAIL PROTECTED]; [EMAIL PROTECTED]
Subject: RE: [newbie] ABIT BD-711 motherboard
problems with Mandrake
Hi Jim,
Thanks for the response. I do not have any of the
devices
)
Onboard IDE: DVD-ROM as master
Onboard IDE2: HP 9100i as master
Anything on the onboard IDE doesn't work...
--Alexander
-Original Message-
From: Nikunj Bansal [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, November 27, 2002 7:12 AM
To: [EMAIL PROTECTED]
Subject: RE: [newbie] ABIT BD-711
? HTH
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Alexander Rayborn
Sent: Wednesday, November 27, 2002 7:17 AM
To: [EMAIL PROTECTED]
Subject: RE: [newbie] ABIT BD-711 motherboard problems with Mandrake
Yes, I can boot into Mandrake after installing from
]
Subject: RE: [newbie] ABIT BD-711 motherboard problems with Mandrake
Are you able to boot into Mandrake normally after the
install is completed? I worry because my existing
Mandrake installation is also not booting up
presumably because it does not seem to recognize the
hard disk
On Wednesday 27 Nov 2002 2:27 pm, Myers, Dennis R NWO wrote:
Wait, if your hard drive is hda then it has to be the master on ide1 so
your cdrom can not be set as master also, you would have to set it as
slave, your HP could be set master if there is no other hard drive on the
ide2 bus. Have
But have you verified that all devices a jumpered to master - not cable
select? Linux doesn't like cable select.
Brian
On Wed, 2002-11-27 at 23:57, Nikunj Bansal wrote:
Hi Jim,
Thanks for the response. I do not have any of the
devices as slaves.
Want to buy your Pack or Services from
