s] SWWP Whisper 200 - looking for a short to ground.
Hi Ron, Alan, and everyone else...
There were good suggestions provided, so I didn't jump in. I was traveling
also, so got into this discussion late. But, I'm usually available (and
almost always willing) to provide whatever knowledge
Hi Ron, Alan, and everyone else...
There were good suggestions provided, so I didn't jump in. I was traveling
also, so got into this discussion late. But, I'm usually available (and
almost always willing) to provide whatever knowledge support I can for
Whisper products. Parts will be a problem,
Hi Allan, although I seem to be subscribed to the small wind forum I have never
received an email or digest from that list. I went online to see if I could
find archived posts just to see if there actually was a small wind forum and
couldn't navigate my way through the list page to find anything
A dumb question perhaps...
Have you posted this topic to the small wind forum?
Allan
Ron, may I suggest you call Ryan or myself at MidNite tomorrow sometime.
Something about that braking situation doesn't sound right. Might be
some kind
of connection with the Clipper/Classic. Maybe not, but won't hurt to talk.
Thanks,
boB Gudgel
360-403-7207
On 10/15/2013 10:29 PM, Ron
Hi Matt, I have a very similar (maybe identical) problem with a Whisper 200
that I've been trying to solve for several weeks. When you say that it's not
performing what exactly do you mean?
My problem surfaced following a lightning storm and everything pointed to the
controller. I replaced the
-wrenches.org
Subject: [RE-wrenches] SWWP Whisper 200 - Looking for a Short to Ground
I've got a Whisper that's not performing and I'm putting this out to the group
in hopes that someone has had a similiar dilemma.
My line to line voltage measurements are the same between t
Not familiar with a Whisper, but here's troubleshooting guide for Bergey
with a short. Does it have a rectifier? That could be burned out.
R.Ray Walters
CTO, Solarray, Inc
Nabcep Certified PV Installer,
Licensed Master Electrician
Solar Design Engineer
303 505-8760
On 10/14/2013 8:55 PM, All
Matt
Sounds like you have checked everything. How about the wiring coming from the
brush holder? Make sure none of them have been chaffed near the pivot. Of
course the brushes might show some arcing too if there is an intermittent
short. If you need an upper casting, complete with stator and a
I've got a Whisper that's not performing and I'm putting this out to the group
in hopes that someone has had a similiar dilemma.
My line to line voltage measurements are the same between the three phases.
However, my line to ground measurements are consistent across only two of the
phase-groun
10 matches
Mail list logo
