Justin
For info where did you buy it from
Regards
Chris
- Original Message -
From: Peter [EMAIL PROTECTED]
To: Justin Fielding [EMAIL PROTECTED]
Cc: soaring@airage.com
Sent: Wednesday, May 25, 2005 11:36 PM
Subject: Re: [RCSE] Highlight HLG and Highlight SLG (DLG) setup?
Hi
Cyno is good for gluing coroplast together
- Original Message -
From: Mark Wales [EMAIL PROTECTED]
To: soaring@airage.com
Sent: Tuesday, April 12, 2005 3:51 AM
Subject: [RCSE] Coroplast Storage Boxes
I drew the box design out on a 4x8 sheet of coroplast. I cut the solid
lines all the
I gave up on the dremel a few years ago after my replacement for the one
that burnt out fell apart ( the armature literally did) in just over a year.
I now use Proxon (made in Germany) you can feel they are much better made
from first use, don't know if you can get them over in the states
Don't know Stevebut the action of clipping a tip is very similar to the
action multiplex recommend to remove the wing from the connectors!! good
point though
I prefer to use the little red wedge.
Chris
- Original Message -
From: Steve Lange [EMAIL PROTECTED]
To: Chris Veitch
The only advice I would add is that if you have a wing that pushes onto a
joiner that goes through the fuz, rather than a centre panel which bolts on,
it is safest to make only one side fixed. i.e. fix the one connector in the
wing and make the other one from the fuz loose. The advantage is
Tom
Re:- During landing, the Sharon doesn't like a lot of radical flap
modulation.
Can you clarify what you mean by this, save me
guessingas I am just kitting my electric one out at present.
TIA
Chris
- Original Message -
From:
Tom Hoopes
To: Stan Myers ;
ChrisChris Veitch (Mr)Sherwood
House150 Chaseley RoadEtchinghillRugeleyStaffordshireWS15
2LNTel 01889
578793Fax 0207 900 2294Mob
07785 772619Email chris @ veitch.org (no
spaces)
Have a look at http://www.llm-electronic.com/ this is a very nice unit. I
am using the 35mhz one in the UK but they also do 72mhz.
Regards
Chris
- Original Message -
From: Adam Till (Cal) [EMAIL PROTECTED]
To: soaring@airage.com
Sent: Monday, January 17, 2005 11:36 PM
Subject: [RCSE]
Hi
I seem to remember that someone in the UK was
keeping servo frames in stock for the HS 5125 as US orders may take some time at
this time of year.
Is there anyone out that does or knows a man
that does ?/
Regards
Chris
Kevin
from http://www.modelspot.com/mpx/stdservo.htm UK multiplex Cockpit BB
20Ncm at 4.8v, Speed 60 dec 4.8v 0.21
Micro 3BB 16Ncm at 4.8v, Speed 60 dec 4.8v 0.17 from an old print I kept.
Regards
Chris
- Original Message -
From: KEVIN KAVANEY [EMAIL PROTECTED]
To: soaring [EMAIL
Great bit of footage...at least it proved the flaps work :-)
- Original Message -
From: Arne Ansper [EMAIL PROTECTED]
To: Tom Watson [EMAIL PROTECTED]
Cc: RCSE [EMAIL PROTECTED]
Sent: Monday, September 20, 2004 9:50 AM
Subject: Re: [RCSE] testing the DC 9 at 11/10 of design limit
On
So what if in certain circumstances a tree or something similar is in the
line of sight ??
- Original Message -
From: Ryan Flowers [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Sent: Wednesday, March 31, 2004 7:58 PM
Subject: Re: [RCSE] 2.4 ghz Digital Spread Spectrum for RC may be Here...
Guys
I have not found a problem getting both tx an rx
crystals (35mhz) for hitec and graupner in the UK. I only use mpx receivers and
the only problem there appears to be the typical supply one.
regards
Chris
/ Original Message -
From:
George Joy
To: [EMAIL PROTECTED] ;
Thanks for the link, there are some articles on-line, for everyone's info I
use babelfish to translate pages on line its not perfect but does very well
the link is as below.
http://babelfish.altavista.com/
Regards
Chris
- Original Message -
From: Dieter @ ShredAir [EMAIL PROTECTED]
programming key" to enter mode 5.
then change the value with
your
3-pos-switch. Press the blue key again to save. turn off your
picolario.
Your
settings are changed now!
Yours
Raphael
http://www.hangflug.ch
-Ursprüngliche Nachricht-----Von: Chris
So how do you set mode 5 up and how does it
actually operate?
Thanks
Chris
- Original Message -
From:
[EMAIL PROTECTED]
To: [EMAIL PROTECTED] ; [EMAIL PROTECTED]
Sent: Sunday, July 20, 2003 6:22 AM
Subject: Re: AW: [RCSE] New USA Picalario
owners...some information
My funniest one was with a brand new 2.8m Multiplex Alpha 27 glider with
centre panel and 2 tips, spent ages checking it out. But when I threw it
off the slope both tip panels came whizzing off. I forgot to put the
joiners between the centre and tip panels in but due to the multiplex
winglock
Guys
I would welcome some opinions and advice
I just bought some pre made 10 cell RC2400 from a reputable supplier
delivered through the post for a brushless twin jet and a 2.7m thermal
soarer permax 600 +3.1GB both prev used 7 cells and BEC.
The 2.7m soarer now climbs well and had no problems,
Some great links on lights for night flying were posted recently,
unfortunatly I seem to have lost these.
Any chance someone can forward these one to me.
Many Thanks
Chris
RCSE-List facilities provided by Model Airplane News. Send subscribe and
unsubscribe requests to [EMAIL PROTECTED]
Sorry guys forget that I just found them.
Rgds Chris
- Original Message -
From: Chris Veitch [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Sent: Saturday, November 30, 2002 7:22 PM
Subject: [RCSE] Night flying lights
Some great links on lights for night flying were posted recently
20 matches
Mail list logo