+0100
Subject: Re: [Tinyos-help] Question about IRIS mote using OC3A,OC3B,OC3C
From: mmar...@math.u-szeged.hu
To: aparicioso...@hotmail.com
CC: tinyos-help@millennium.berkeley.edu
Hi Sofia!
On Thu, Jan 27, 2011 at 4:25 PM, sofia aparicio
aparicioso...@hotmail.com wrote:
Hello,
Seems
Hello,
Seems ok, but not sure how you access those pins. How did you verified
that your code does not work? You cannot be sure that these pins are
available on the 51-pins.
I am using a MDA100 sensor board connected to my IRIS mote. I can see the
signals in OC3A, OC3B and OC3C using an
Hi Sofia!
On Thu, Jan 27, 2011 at 4:25 PM, sofia aparicio
aparicioso...@hotmail.com wrote:
Hello,
Seems ok, but not sure how you access those pins. How did you verified
that your code does not work? You cannot be sure that these pins are
available on the 51-pins.
I am using a MDA100
Hello,
I would like to configure in Fast PWM mode without prescaler and toggling
OCR3A,OCR3B and OCR3C at the same time. I do the following:
SET_BIT(DDRE,3); OCR3A
SET_BIT(PORTE,3);
SET_BIT(DDRE,4); OCR3B
SET_BIT(PORTE,4);
SET_BIT(DDRE,5); OCR3C
SET_BIT(PORTE,5);
TCCR3A=0x57;
TCCR3B=0x19;
I'm afraid I don't have the patience to apply the
necessary brain cells to the hermeneutics of the
ATMEGA manual right now. My only advice is to put
it all down for a day or two and then re-read _every_
section of the manual that might apply, looking for
some small detail that got buried in the
Hi Sofia!
I know the atmega1281 timers in and out, I am rewriting the timer
subsystem (or at least I am writing a new one for the atmega128rfa1).
On Wed, Jan 26, 2011 at 4:01 PM, sofia aparicio
aparicioso...@hotmail.com wrote:
Hello,
I would like to configure in Fast PWM mode without
Miklos Maroti wrote:
Hi Sofia!
I know the atmega1281 timers in and out, I am rewriting the timer
subsystem (or at least I am writing a new one for the atmega128rfa1).
On Wed, Jan 26, 2011 at 4:01 PM, sofia aparicio
aparicioso...@hotmail.com wrote:
Hello,
I would like to configure in
Hi Michael,
On Wed, Jan 26, 2011 at 10:51 PM, Michael Schippling sc...@santafe.edu wrote:
Miklos Maroti wrote:
Hi Sofia!
I know the atmega1281 timers in and out, I am rewriting the timer
subsystem (or at least I am writing a new one for the atmega128rfa1).
On Wed, Jan 26, 2011 at 4:01
I was once inspired to add a bunch of stuff to the doc/wiki
but I selected a day on which it refused to allow me to create
a login...maybe all days are like this? So I keep to myself.
The 51 pin expansion connector pinouts should match, although
I just paid attention to the micasb sensor board