a) Connect to the router with the following terminal settings: 1200 baud rate No parity 8 data bits 1 stop bit No flow control
You no longer see any output on your screen. This is normal. b) Power cycle (switch off and then on) the router and press the spacebar for 10-15 seconds. This generates a signal similar to the break sequence. c) Disconnect your terminal and reconnect with a 9600 baud rate. You should now be in ROM Monitor mode. d) have fun :) -----Ursprüngliche Nachricht----- Von: Andrew Blevins [mailto:[EMAIL PROTECTED]] Gesendet: Montag, 17. Dezember 2001 20:42 An: 'Michael Desrosiers'; [EMAIL PROTECTED] Betreff: RE: cisco 2513 router Console in to the router, and then when the router is booting, you need to hit the *break* keystroke (it depends on the OS you are using to connect with), this will interupt the post, and allow you to reset the config register. -----Original Message----- From: Michael Desrosiers [mailto:[EMAIL PROTECTED]] Sent: Saturday, December 15, 2001 7:51 PM To: [EMAIL PROTECTED] Subject: cisco 2513 router Hello all, I just received a cisco 2513 router w/16 Meg of Flash that I purchased on ebay. The problem seems to be I cannot reset the enable password to redo the configuration. I have found some documentation on cisco's site in reference to resetting the config register to 0x142, but I cannot get rommon to get back to a prompt to reset it. Any ideas would be greatly appreciated8:( Thanks Mike
