emanuel

you can also set parameter BANDPASS FILTER in MULPLT.DEF and the filter is always on when plotting from eev with option po

jens

On Tue, 9 Oct 2012, Emanuel Antunes wrote:

Dear All,

I have searched for a solution to this problem but was unsuccessful in doing
so. You have been most helpful in helping me solve my previous problem, so
once again I resort to your collective expertise. I would like to know if it is possible to set up a default filter so that
wavefiles are always opened with that filter when one uses mulplt or option
?p?/?po?in eev. In order to toggle between single channel or multichannel modes.
Alternatively, can one fix a specified filter during the entire mulplt
session?
Thanks in advance.

Best regards,


Emanuel Antunes

Integrated Master Degree (MSc) in Physics Engineering
M.Sc. Thesis - Seismology Laboratory Instituto Superior Técnico (IST) - Lisbon Technical University (UTL)





_______________________________________________
seisan mailing list
[email protected]
http://mailman.uib.no/listinfo/seisan

Reply via email to