Dear Branden,

Thanks for the tip, I had already tried that, it does filter the raw input but 
only until one switches the mode in mulplt. For instance, if you toggle the 
single trace mode, you loose the filtering and it returns to just showing the 
raw data. That’s not exactly what I was looking for...

Best,

Emanuel Antunes

Integrated Master Degree (MSc) in Physics Engineering
M.Sc. Thesis - Seismology Laboratory 
Instituto Superior Técnico (IST) - Lisbon Technical University (UTL)
On 2012/10/09, at 18:06, Branden Christensen wrote:

> Emanuel:
> 
> 
> One can fix a specified filter during the entire mulplt session. 
> 
> e.g., 
> 
> osop@queretaro:/opt/seismo/WAV$ mulplt
>   Filename, number, filenr.lis (all)
>   Continuous SEISAN data base: cont 
>   Large SEED volume: conts
>   Bud archive: bud
>   SEISCOMP archive: scp                                                       
>   
> 1
>  Read headers from files:
>  2011-11-05-2149-08S.MAN___038                                                
>    
>                                                     
>   Plot options: Interactive picking          Return 
>                 Multi trace plot on screen, def (0) 
>                 Multi trace plot on screen      (1) 
>                 Multi trace plot on screen+laser(2) 
>                 Multi trace plot on laser       (3) 
>                 Continuoues on screen           (4) 
>                 Continuoues on screen + laser   (5) 
>                 Continuoues on laser            (6) 
>                 Stop                            (q) 
> 0
>   Low and high cut for filter, return for no filter
> 10 15
> 
> This will set a bandpass filter from 10 to 15 Hz for the entire mulplt 
> session.
> 
> 
> Atte.
> 
> 
> Branden C. Christensen
> Director, OSOP
> [email protected]
> www.osop.com.pa
> Volcan, Panama
> 
> 
> 
> 
> 
> 
> On Tue, Oct 9, 2012 at 4:53 PM, Emanuel Antunes <[email protected]> 
> wrote:
> Dear All,
> 
> 
> I have searched for a solution to this problem but was unsuccessful in doing 
> so. You have been most helpful in helping me solve my previous problem, so 
> once again I resort to your collective expertise. 
> I would like to know if it is possible to set up a default filter so that 
> wavefiles are always opened with that filter when one uses mulplt or option 
> “p”/“po” in eev. In order to toggle between single channel or multichannel 
> modes. Alternatively, can one fix a specified filter during the entire mulplt 
> session?
> Thanks in advance.
> 
> Best regards,
> 
> 
> Emanuel Antunes
> 
> Integrated Master Degree (MSc) in Physics Engineering
> M.Sc. Thesis - Seismology Laboratory 
> Instituto Superior Técnico (IST) - Lisbon Technical University (UTL)
> 
> 
> 
> 
> 
> _______________________________________________
> seisan mailing list
> [email protected]
> http://mailman.uib.no/listinfo/seisan
> 
> 

Emanuel Antunes

Integrated Master Degree (MSc) in Physics Engineering
M.Sc. Thesis - Seismology Laboratory 
Instituto Superior Técnico (IST) - Lisbon Technical University (UTL)




_______________________________________________
seisan mailing list
[email protected]
http://mailman.uib.no/listinfo/seisan

Reply via email to