Dear wendy
Thank you for the answer,you are rigth, and if 9hz will keep stable the wa
filtre i can use it for an event bigger than 2

Best regards
Gonzalo
El jueves, 24 de julio de 2014, McCausland, Wendy <[email protected]>
escribió:
> Gonzalo,
>
> The Nyquist frequency for a 20Hz sampling rate is 10Hz. That is why the 9
Hz upper corner works but the 20Hz upper corner does not.
>
> Wendy
>
> <<<<<<<<<<<<<<<>>>>>>>>>>>>>>>
> Wendy McCausland
> Seismologist
> USAID-USGS Volcano Disaster Assistance Program
> 1300 SE Cardinal Court
> Building 10, Suite 100
> Vancouver, WA 98683
> +1 360 993 8985 (office)
> +1 360 823 7309 (cell)
> +1 360 993 8985 (fax)
> <<<<<<<<<<<<<<<>>>>>>>>>>>>>>>
>
>
>
> On Thu, Jul 24, 2014 at 1:46 PM, gonzalo antonio fernandez marañon <
[email protected]> wrote:
>>
>> Dear Jens.
>> Thank you so much!!! for your prompt response!!!
>> Best Regards.
>> Gonzalo F
>>
>>
>> 2014-07-24 16:13 GMT-04:00 Jens Havskov <[email protected]>:
>>>
>>> gonzalo
>>>
>>> the simplest would be to not use the additionbal filter,it is only
there to avoid unsstability when determining Ml for very small events, say
Ml < 2. use the filter at 9 Hz would also be ok.
>>>
>>> jens
>>>
>>>
>>> On Thu, 24 Jul 2014, gonzalo antonio fernandez marañon wrote:
>>>
>>>> Dear Seisan Gurus.
>>>> Have a wonderful day, I have a question about the Wood Anderson filter
to
>>>> calculate the Ml magnitude.
>>>>
>>>> 1. We are getting data from a Broad Band station from another Data
Center,
>>>> the sampling rate is 20sps
>>>>
>>>> 2. The WA Filter is set from 1.25 to 20 (I assume it is a Band Pass),
of
>>>> course I can modify the valu in MULPLT.DEF
>>>>
>>>> 3. When I tryed to get the Ml magnitude (following the manual
procedure)
>>>> with this station I got an error which told that it is not possible
filter
>>>> due to the sampling rate, of course it is logical.
>>>>
>>>> 4. So I decided to change the filter range from 1.25 to 9 in
MULPLT.DEF,
>>>> then I got no error and I could get the Ml magnitude.
>>>>
>>>> As the Broad Band station has 20sps the maximun frquency work is 10
rigth
>>>> (due to the sampling theorem) that is the reason I put 1.25 to 9 for a
WA
>>>> filter.
>>>>
>>>> The question are:
>>>>
>>>> Does anyone think (I accept all comentaries) that the Ml magnitude for
a
>>>> local earthquake can be used?
>>>>
>>>> Is the filter range logical?
>>>>
>>>> Thank you for your time.
>>>>
>>>> Best Regards.
>>>>
>>>> Gonzalo F
>>>>
>>>>
>>
>>
>> _______________________________________________
>> seisan mailing list
>> [email protected]
>> http://mailman.uib.no/listinfo/seisan
>>
>
>
_______________________________________________
seisan mailing list
[email protected]
http://mailman.uib.no/listinfo/seisan

Reply via email to