Don,
SK Fiber makes very good shafts, though I haven't tried the Tri-Tec. I use
the Pure Energy A for most of my long drivers. Here's an iron shaft option, if
you want to experiment...
I found an inexpensive graphite shaft which seems to play
as well as my old $15 Apache PM-30i A-2 shafts. It's a Hireko proprietary
filament wound Powerflex FW-501 combo R/S iron shaft (I'm using the R
softstepped one club with a 3/8" slope), spec'd at 88 grams, but is actually
81-82 grams (same weight as my Apaches), torque 3.0...about where I like
it. Consistency shaft-to-shaft was quite good on my NF2, with a spread of
only .023" for ten shafts, all readings taken on the NBP...or a
little less than 5 cpm, I think. Seven of the shafts has spines less than 2 cpm
and the other three were .013", .015" and .016", or a little less than 3 to
a hair more than 3 cpm. Cost is $6.30 each/10 shaft quantity. Tip sensitivity
was .026"/inch, or about 5 cpm. These shafts have a profile that feels a little
heavier than many graphites the same weight...which is a feature I like because
it stabilizes my swing on the short irons. Impact feels very solid and shaft
action is smooth. Played three rounds with them and had three straight
77s...if I could putt, they would have been 74s or less. :-)
Used Pro Perimeter heads ($6.95) with these shafts, very clean looking
cavity backs with low offset, and used Hireko's Soft Tread grips ($1, like
a Softee). Swingweight across the assembled 3-PW set was D2.9 to D3.5, or .6 of
a point spread (except for SW at D4.7, which I wanted heavier). Also, tried the
NBP-COG alignment, which seems to result in a very straight ball flight (though
most of these shafts really didn't need any particular alignment). Club length
is standard graphite lengths. Component cost about $15 a club. Time will tell,
but these might be my "cheapo" iron success of the year.
Bernie
Writeto: [EMAIL PROTECTED]
|
- ShopTalk: Again Don Flatgard
- Re: ShopTalk: Again Bernie Baymiller
- Re: ShopTalk: Again Don Flatgard
- Re: ShopTalk: Again Bernie Baymiller
- Re: ShopTalk: Again George Huson
- Re: ShopTalk: Again Burgess Howell
- Re: ShopTalk: Again Bernie Baymiller
- Re: ShopTalk: Again Don Flatgard
- Re: ShopTalk: Again Bernie Baymiller
- Re: ShopTalk: Again Don Flatgard
- Re: ShopTalk: Again Bernie Baymiller
- Re: ShopTalk: Again Don Flatgard