I have a maltby digital analyzer with two bolts on the ratcheting clamp. The problem I have is when I twang the shaft, the shaft makes noise in the front of the clamp like it's a little. How do I adjust?
Sent from my iPhone On Apr 3, 2013, at 9:38 AM, Roy Nix - AGCP Director <r...@agcpgolf.com> wrote: > On 4/2/2013 10:07 PM, GolfDNA Studio wrote: >> My Golfsmith unit is about 15 years old, digital with the LED readout and >> the 1 button reset. >> About 2 years ago I bought a new upper block assembly from Golf Mechanix and >> it worked great. >> Now I am getting repeatability problems when checking the same shaft in the >> same orientation. >> When it is working great I would get an average of 319, then >> reclamp and get 319 or 318 or 320. >> Now when I use the unit and check/reclamp 5X’s I get numbers like 320 / 320 >> / 315 / 316 / 316. >> >> Any idea how to fix or make consistent? I can live with the unit being off >> by 1 cpm but not 5 cpm. >> >> If I can’t get my unit working probably, I will just buy a new Club Scott IV >> from John Kaufman. >> Anyone use his pneumatic clamp mechanism and if so, how do you like it? 1 >> or 2 cylinders? >> >> Kind regards, Harry >> www.GolfDNA.com > Many AGCP members have purchased an after market hex bolt to replace the > Clutch that comes with the machine and use a torque wrench to dail in > consistent clamp pressure to get consistent readings. > > See it here > http://www.agcpshoponline.com/auditor-strain-gauge-clamp-screw-upgrad.html > > Roy Nix > -- Shoptalk ** Sponsored by the new Aldila Voodoo. Learn more at > http://aldilavoodoo.com/