I bought a SOHO card a while back that was recognized as a tulip card. I
had to get the new tulip.c that came on the floppy with the card and
compile it into tulip.o and replace the tulip.o that comes with RedHat 6.0.
After rebooting everything worked fine.
Tim.
At 12:34 AM 09/25/1999 -0500, tom carlile wrote:
>there is a handy link off the siglinux site to the mail archive.
> http://locutus.csres.utexas.edu/siglinux
>i'd check your routes and make sure the default route goes through
>the eth0 interface. you should probably read the Ethernet-HOWTO
>also.
>
>Nathan Sportsman wrote:
>
>> I installed Redhat 6.0 on a machine with a 20 dollar NIC card. It found
and identified the card as a Digital Tulip on installation. The link light
on the nic is on at start up and through the boot
>> process until it comes to initializing the ethernet iface. I can ping
the ip address I gave the box, but I can't ping any other computers on my
network. Someone mentioned to me there was an entire
>> thread about these cards a couple of months back. Can someone either
point me to the SigLinux archive or give an explanation on how to fix it.
Nathan
>
>--
>tom carlile [EMAIL PROTECTED]
>professional systems wrangler
>
>
>
>---------------------------------------------------------------------------
>Send administrative requests to [EMAIL PROTECTED]
>
---------------------------------------------------------------------------
Send administrative requests to [EMAIL PROTECTED]
