> In a message dated 7/19/99 3:00:05 AM Pacific Daylight Time, [email protected] > writes: > > << Parts: > 1 x 9 Volt DC 200 mAmp (amperage doesn't matter, this was the > cheapest), AC power outlet adaptor.[ you could use a 12 Volt adaptor, > generating time would shorter for same PPM] >> > > Ivan > > Been following your protocol since you first posted the instructions. But 9v > transformer tests out from12 to 15 volts and 12 v transformer tests out to 19 > volts. I've been using the 9v transformer. Does the voltage variance affect > the CS? > > Wong
Wong, You must have missed the previous paragraph where I said the circuit operates at about 12V :-). Charles is quite right but the voltage drops only about half a volt or so as the current draw is very low, following this protocol. (0.5mA cold water, 1mA hot water) These instructions are correct for a 9V adaptor with an open circuit voltage of around 12V. Higher voltages give a faster reaction time, but the beauty of this system is that there is no need for a current limiter, which might be required for voltages over 15 -18V. BTW, how is your system working, are you happy with the results? Ivan. -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] List maintainer: Mike Devour <[email protected]>
