The normal distance is 1 1/2"
If any part of the electrodes is closer to each other, the brew time goes down with the PPM at auto off and the current density on those closer parts becomes greater.
 Less time, less silver.
You can reduce the current build up time by rotating the free ends closer, then rotate them apart to parallel for PPM...or just start the batch with some CS from a previous batch.

The closer parts will also erode away faster than the more distant.
 Not the best idea for electrode longevity.

The electrode design is for even wear for maximum life, eliminating current density "hot spots" and edge and corner ion discharge current density concentrations.


Ode


At 08:12 PM 8/25/2008 +0100, you wrote:
I have a silverpuppy. Can anyone tell me if it is ok to have the electrodes one and a half inches apart approximately for the whole brewing time? I ask because I did this today and knocked nearly two hours off the brewing time. They are usually about two inches apart. dee


--
The Silver List is a moderated forum for discussing Colloidal Silver.

Instructions for unsubscribing are posted at: http://silverlist.org

To post, address your message to: [email protected]

Address Off-Topic messages to: [email protected]

The Silver List and Off Topic List archives are currently down...

List maintainer: Mike Devour <[email protected]>