Wayne Fugitt wrote:
Good Morning Ode,

Sounds like you are in a good mood today,

and......... thinking clear as well.

>> At 05:42 AM 8/26/2008, you wrote:

>> If any part of the electrodes is closer to each other, the brew time goes
down with the
>>  PPM at auto off and the current density on those closer
parts becomes greater.
>> You can reduce the current build up time by
rotating the free ends closer, then rotate
>>  them apart to parallel for
PPM...or just start the batch with some CS from a previous batch.

  I
follow your logic on this and agree with you 100 %.

  I have thought
about this a lot, and in fact thought of building a device to automatically change the spacing of the electrodes at just the right time, gradually, as
needed.

  It would be simple enough for some of us to do, and I could
certainly do it.

  Selecting they right sensors and electro mechanical
devices to determine the speed and smoothness of the movement would not be so easy, but it would be possible.

Actually it would not be that hard. If you are running a constant current or current limiting, you monitor the voltage across the electrodes, and if supplying a constant voltage, the current through the electrodes. You take that signal (as a voltage) and subtract it from a reference voltage and amplify that up to be sufficient to run a small DC motor. The DC motor is hooked up to move the electrode toward or away from the other electrode, so that the distance between the electrodes will vary to maintain the signal equal to the reference signal. Pretty simply control system design actually.

Marshall


--
The Silver List is a moderated forum for discussing Colloidal Silver.

Instructions for unsubscribing are posted at: http://silverlist.org

To post, address your message to: [email protected]

Address Off-Topic messages to: [email protected]

The Silver List and Off Topic List archives are currently down...

List maintainer: Mike Devour <[email protected]>