Mike, Good answers! About the last question on guage- I asked my husband (which I should have done to start with since he's so smart) and he said that it's not really 14 or 16, but .16 and .14 when you're talking guages. It's the same with shotguns. Karen
---------- > From: M. G. Devour <[email protected]> > To: [email protected] > Subject: Re: CS>silver wire > Date: Thursday, August 05, 1999 3:50 AM > > > The 16 ga. silver wire I've been using was given to me by someone > > who said it was "pure". I just ordered some 14 ga. .999 myself and > > was surprised to find that I couldn't tell the difference between > > the two in size. So does the 14 ga. actually last much longer than > > the 16 ga. ? ( A dollar a foot longer!?) > > According to my ARRL Handbook, 16 gauge is 0.051" diameter and 14 > gauge is 0.064". So, no there's not a *lot* of difference in > thickness. However, the cross-sectional area goes up by almost 60%, > though, so there is a decent difference in volume of metal. > > It took me a long time to see a change in diameter on my 12 gauge > wires before I finally replaced them. At least a couple of years. > > As to cost, you probably don't need to pay more than a few bucks a > foot, so it's not too much difference, costwise, no matter what. > > > Anyway, I noticed that the 14 ga. was somewhat softer than the 16, > > so I figured the purity must be higher. > > Softness/hardness can vary depending on the processing of the metal, > totally independant of purity. It'll depend on how the wire has been > heated and drawn exactly what hardness state it will be left in. > Fully annealed, it'll be soft as butter. Drawing, as in pulling it > through a die to change its diameter, will harden it. > > > How does one get their silver tested? No jeweler or pawn shop > > around here could do it. By the way, who came up with the guage > > numbers getting SMALLER when the wire gets fatter? > > Good questions! > > As far as purity is concerned, if you want to make sure of what you > have, buy it from a source that will guarantee and document the > purity of the material. This includes a lot of chemical and materials > supply houses that sell to industry and research. They'll provide an > analysis by batch, either routinely or by request. Expect to pay more > for the service, though. > > Otherwise, just making sure the supplier is sending you "fine" or > "extra fine" silver wire, at least .999 pure, rather than sterling, > should be enough if they are at all competent and honest. > > There is enough difference between pure silver and sterling that > the jewelers and metal workers buying the stuff would know the > difference and raise hell with that supplier if they couldn't tell > the difference between "fine" and sterling silver! > > As to wire gauge? Ahh ... ahem ... cough... I don't know. <GRIN> > > Be well, > > Mike D. > [Mike Devour, Citizen, Patriot, Libertarian] > [[email protected] ] > [Speaking only for myself... ] > > > -- > The silver-list is a moderated forum for discussion of colloidal silver. > > To join or quit silver-list or silver-digest send an e-mail message to: > [email protected] -or- [email protected] > with the word subscribe or unsubscribe in the SUBJECT line. > > To post, address your message to: [email protected] > > List maintainer: Mike Devour <[email protected]>

