Here is an use of the TDS...quality of the "distilled" water Alex Torres -----Original Message----- From: James Osbourne, Holmes <[email protected]> To: '[email protected]' <[email protected]> Date: Thursday, September 02, 1999 8:56 AM Subject: RE: CS>Water for CS Research, please help!
>Hi Vickie, > >The minute changes in conductivity caused by remaining dissolved solids in >various distilled waters has a dramatic effect on yield with HVAC >processes, by my direct observation. From reading others experience with >LVDC, it is apparently the same. Since particle size is probably affected >by current, it probably changes that also, but not as dramatically as >yield, suspect. I think yield plotted against conductivity is probably a >curve which starts out relatively flat, and turns up steeply as resistance >decreases and current increases. When I get a amp meter on my rig, I will >log that for sol concentration Vs current. The cost of particle size >measurement is a continuing barrier for me. > >Some say that a starting PPM---sorry, I do not have that in mS---of about >0.8 is ideal in the nominal 10KV AC range. > >James Osbourne, Holmes > >[email protected] > >-----Original Message----- >From: Victoria Welch [SMTP:[email protected]] >Sent: Wednesday, September 01, 1999 7:10 PM >To: Silver-List >Subject: CS>Water for CS Research, please help! > >Hi everyone and thanks in advance! > >I'm trying to understand why there seems to be a variation in startup >currents when using Distilled Water (DW). > >The stuff I am using is from a company called Cullyspring Water >Company. Notes from the label are as follows: > >Distilled Water > >Member International Bottled Water Association. > >Purified to USP standards by seeam distillation, reverse osmosis, >deionization, sub micron absolute filtration and ozonation. > >If y'all could look at what you are using and let me know what it is and >if it might say anything similar to the above. > >I would be especially greatful for information from folks who can and do >check initial starting current flow and perhaps let me know what your >starting current is also if they are using LVDC/LVAC/whatever. > >I've seen some data flow by (Ole Bob here) and there seems to be a vast >difference in current flow from what I am getting and I am wondering why >and what the differences might be. > >If you wish to email me directly instead of the list, that would be OK >and would probably take the load off the list :-). > >I'll correlate and summarize to the list if there is interest. > >Thanks and take care, Vikki. >-- >Victoria Welch, WV9K, DoD#-13, Net/Sys/WebAdmin SeaStar.org, >vikki.oz.net >"Walking on water and developing software to specification are >easy as long as both are frozen" - Edward V. Berard. >Do not unto others, that which you would not have others do unto you. > > >-- >The silver-list is a moderated forum for discussion of colloidal silver. > >To join or quit silver-list or silver-digest send an e-mail message to: >[email protected] -or- [email protected] >with the word subscribe or unsubscribe in the SUBJECT line. > >To post, address your message to: [email protected] > >List maintainer: Mike Devour <[email protected]> >
