In a message dated 11/6/00 6:42:04 PM EST, bober...@swbell.net writes: << Subj: CS>HVAC ARC Structured water Date: 11/6/00 6:42:04 PM EST From: bober...@swbell.net (Robert L. Berger) Reply-to: silver-list@eskimo.com To: silver-list@eskimo.com (silver-list) Hold on to your hats kiddies!!! "Ole Bob" is about to increase the interest in neon sign transformers. While running the HVAC ARC method in a clear glass jar I noticed that when I gentled stirred the CS I could see the difussion of a heavier liquid in the DW. In talking to Dr Bill Biagioli today, who makes ARC CS reported that the viscosity of the CS has increased 50% over the value of the raw DW. At this very monent I and running a batch and I can see the lines showing the difference in refraction of the two liquids. By the way Dr. Bill's TEM's show the same energy patterns that mine does. Ok Gurus what is going on???? "Ole Bob" >>
Ole Bob: First, how do you know that the viscosity has increased 50%? Was the viscosity actually measured? If so, how was the bath sampled? If there was such a large viscosity gradient sampling would have been difficult. Let's assume that the viscosity had indeed changed (increased, I assume) by 50% for a nominal CS concentration in the range of 10 - 15 PPM. Using LVDC CS for comparison, measure its viscosity and compare it to the arc-made, HVAC CS. Assuming that the CS itself was not responsible for the greater viscosity (which could be demonstrated if the viscosities of LVDC and arc-made HVAC CS were compared), there is only one other possibility, the structure of the water molecules has changed. Since the viscosity has increased, the most likely explanation is that the symmetry of the molecular ordering has been extended (beyond the typical short range ordering in common water) and perhaps is beginning to take on an orderly pattern similar to liquid water at 0 degrees centigrade just before it freezes. In any case, greater order (more structure) would produce higher viscosity because there are less "slip planes" available for the shear caused when one group of molecules slides past another group. Roger -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: silver-list-requ...@eskimo.com -or- silver-digest-requ...@eskimo.com with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: silver-list@eskimo.com Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <mdev...@eskimo.com>
