Brita is right on...
I would suspect the water had been contaminated by detergent residue in the
brewing container. Rinse,rinse,rinse. Don't clean between batches. Store with a
cover.
                                                        Chuck
Don't Panic! It's all right. Everything is going to be just fine.
 OK, panic a little... 

On Sun, 30 Dec 2001 01:36:57 -0500, "bvjones" <[email protected]> wrote:

>it looks to me that your generating process is occuring way too fast. most
>likely it's the "distilled" water, or else you had some other residue in the
>jar. try rinsing it out with hydrogen peroxide and then rinsing it thoroughly 
>(3
>or 4 ) times with the distilled water, then do the generating again spacing 
>your
>electrodes 2 inches apart, exactly opposite each other.
>
>In  my experience heating the water will speed the generating up somewhat but
>not as quickly as "within 5  minutes". for 32 ozs of water it should take at
>least 30 minutes to an hour before you see anything other than a very few
>"bubbles" on the negative electrode
>
>hope this tides you over 'till more experienced folks send their comments.
>
>Brita.


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>