Hello John, How does one go about adding a bubbler to a one quart jar?
John -----Original Message----- From: John A. Stanley [mailto:j...@natel.net] Sent: Monday, May 20, 2002 2:46 PM To: silver-list@eskimo.com Subject: Re: CS>my 1st. batch In article <eheeiadbdejhokgffcedmeaaceaa.jree...@sbcglobal.net>, "John Reeder" <jree...@sbcglobal.net> wrote: >Hello Roger, > >I am using a Colloid Master 777 to make my cs. It has been turning >out a pale to medium yellow at about 12-15 ppm according to my Hanna >tester. I poured some in my wife's drinking water - plastic bottle >just opened (Costco brand), and it turned pink, measuring about >20 ppm ??? I poured it out, yellow okay, pink, no. Probably your >batch didn't reach the shutoff point was because the electrodes >needed to be scrubbed. Mine does the same thing unless I do one >scrub during the process. When I added an aquarium bubbler for stirring to my Colloid Master it eliminated crud build-up on the electrodes and the CS is now completely clear instead of pale yellow. After each batch I wipe the electrodes with a paper towel, and all that comes off is a little gray stuff. Before adding the bubbler there would be little piles of gray stuff on the bottom of the jar below each electrode. My advice is that you add some sort of stirring to your set-up (either a bubbler or mechanical stirring with a small motor.) -- John A. Stanley j...@natel.net -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: silver-list-requ...@eskimo.com -or- silver-digest-requ...@eskimo.com with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: silver-list@eskimo.com Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <mdev...@eskimo.com>
