A little quick math shows this to not be possible. If you are using .999 pure
silver, the minimum recommended, and producing 10 ppm CS, and drinking an ounce
a day, this would be as follows.

Maximum lead content if 100% of impurities were lead (when in fact the main
impurity is copper) is 10 ppb.  Drinking 1 oz a day would be equivalent to
about 1/100 of that level in the water if you drink 100 oz of water a day. This
give an equivalent lead intake if it were in your drinking water of .1 ppb.

The EPA lists the maximum contamination level for lead to be 0.015 mg/Liter,
which is .015 ppm, or 15 ppm.  Thus the maximum amount of lead you could get
this way a day is 150 times less than the EPA maximum, and that is likely off
by about 100:1 since the lead contamination in silver will will not be 100% of
the impurities, but closer to 1%.

Marshall

Janine Meunier wrote:

> Hi,
>
> I haven't been here in awhile but still using CS going on 2-3 years. I was
> wondering if anyone has ever had their homemade CS tested for lead content?
> I make my CS with the 3- 9 volt battery method and 2 .999 silver ingots.
> Recently a medical professional said that there is lead in the silver and
> that the levels are too high to be safe. What do you guys have to say?
> Thanks very much.
>
> Sincerely,
> Janine
>
>   ------------------------------------------------------------------------
>                   Name: winmail.dat
>    winmail.dat    Type: application/ms-tnef
>               Encoding: base64


--
The silver-list is a moderated forum for discussion of colloidal silver.

Instructions for unsubscribing may be found at: http://silverlist.org

To post, address your message to: [email protected]

Silver-list archive: http://escribe.com/health/thesilverlist/index.html

List maintainer: Mike Devour <[email protected]>