Dick & other list members,

(Dick's question was sent to me privately, but I thought my answer might
help others)

> Question.  In using the LM334Z and the 330ohm resistor in the circuit of a
> battery powered CS unit, why would one have to use (3) 9 volt batteries?
Would
> this system work with (1) 9 volt battery?  The output is so small that a
> single 9 volt should run this circuit, yes?
>
> Dick

The initial voltage needs to be more than 9 volts to start drawing 0.2 ma
immediately.  It may take 16 to 20 volts or so for the CS generation to
start up "full tilt".  If you start with just 9 volts, you will have no idea
how long it takes for the current to ramp up to 0.2 ma., unless you monitor
it with a current meter.  As time progresses, the voltage drops more and
more.  Probably after 4 hours, it would be down to 9 volts or less, and you
could disconnect the other two batteries if you wanted.  But why bother?
0.2 ma is a VERY small load for the batteries, and they will last a very
long time.

Ohm's Law is voltage (E:  used to be called Electromotive force) = current
(I) times resistance (R).  E = I * R.  The DW between the electrodes has a
certain resistance.  As CS is produced, silver ions form in the DW and the
resistance goes down.  Since the current is a constant value, the voltage
measured across the electrodes will drop with time, and end up less than two
volts after 24 hours.

In my case, the initial voltage was 17 volts.  Using Ohm's Law. R = E / I =
17 / .0002 = 85,000 ohms.  If we only had 9 volts available, then the
initial current will be I = E / R = 9 / 85000 = about .0001 amp or 0.1 ma.
So silver production at startup would only be half as much as when the
current finally gets to 0.2 ma.

At the end of the brew in my case, R = 1.6 / .0002 = 8000 ohms.  So the
resistance of the DW has dropped by a factor of almost 10 due to the
addition of the silver ions.  (Silver Colloids are also produced, but they
don't affect the resistance of the liquid.

Bottom line - use a voltage of at least 20 volts but not more than 38 volts
(the maximum voltage rating for the LM334 is 40 volts) to ensure your CS
production is consistent from brew to brew and not varying some with the
quality (electrical resistance) of the DW.  27 volts (3 batteries) is a good
choice.

--Steve Y.

>
>



--
The silver-list is a moderated forum for discussion of colloidal silver.

Instructions for unsubscribing may be found at: http://silverlist.org

To post, address your message to: [email protected]

Silver-list archive: http://escribe.com/health/thesilverlist/index.html

List maintainer: Mike Devour <[email protected]>