Steve, Very good explanation! Another alternative is to quadruple the wetted area by bending a long length of 12 ga into a "W" for the anode and cathode.
This reduces the initial resistance enough so a simple 9V battery and 27k to 47k resistor is all that is needed to stabilize the current. It does not have to be perfect. Since there is a rash of acronyms recently, this might be called a RSULVCCCSG, or "Resistive-Stabilized Ultra Low Voltage Constant Current Colloidal Silver Generator":) My runs show less than 10% change in current which is negligible. The nice thing is a 9V alkaline battery has a very stable 8.5V output over most of its life. Most 9V alkalines have over 500 milliampere-hours of capacity, or 1,800 Coulombs. If you draw 6 Coulombs per 10 oz glass, there is enough for 300 glasses, or almost a year. Since there is very little black crud wasted, Faraday's equations are more accurate. For example, 6 Coulombs would deposit about 22 ppm in an 8 oz glass in 15 hrs at 110 ua. Here's the equations: hrs = 15 ; hours mnt = 0 ; minutes I = 110e-6 ; current in Amperes oz = 10 ; ounces ml = 29.57 * oz ; milliliters x = 1e6 * 107.87 / 96485 ; x = 1117.99 get rid of Silver constants sec = hrs * 3600 + mnt * 60 ; seconds C = I * sec ; coulombs ppm = x * C / ml ; parts per million Going through the calculations, hrs = 15.15 ppm = 22.68 Considering the recent posts from Ole Bob, the PWT may be off calibration by a considerable amount. Using very low current and counting Coulombs might be a bit more accurate. Of course, I always rely on the salt test for confirmation. It's a lot prettier:) Best Regards, Mike Monett -- The silver-list is a moderated forum for discussion of colloidal silver. Instructions for unsubscribing may be found at: http://silverlist.org To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>

