Well, the reading of ppm after 3 days is still the same as on the day the batch was made.
Jurek

----- Original Message ----- From: "Ode Coyote" <[email protected]>
To: <[email protected]>
Sent: Saturday, January 15, 2005 9:55 PM
Subject: Re: CS>How many ppm in CS





PPM meters read differently in silver ions than in dissolved metallic salts.
Use straight reading in water and double it for silver. [They aren't all
the same , but close]
Your final is more like 10 PPM ... if measured the day after the batch was
made.
Ode

At 04:22 PM 1/13/2005 +1030, you wrote:

How could you explain the following:

I used 240 ml of distilled water and TDS (total dissolved solids) meter to
measure number of ppm.
The reading of ppm before applying the CS generator with about 26V from
batteries:  2ppm
After 10 min and stirring the water I read 3 ppm
After next 10 min the reading was 5 ppm
Finally after 25 min I had 7 ppm on my meter.

Can we say that the amount of  silver  liberated in my distilled water was
5ppm?

Regards
Jurek

Can we say that the
----- Original Message ----- From: "Mike Monett" <[email protected]>
To: <[email protected]>
Sent: Thursday, January 13, 2005 8:27 AM
Subject: Re: CS>Argyria cure


Re: CS>Argyria cure
From: Tony Moody
Date: Wed, 12 Jan 2005 10:49:28
http://escribe.com/health/thesilverlist/m76893.html

 [...]

 > I make  and  sell  the ColSilGen cc which  is  a  colloidal silver
 > generator with  constant current set at 1mA and using a  single 9v
 > battery. Two silver rods 2.5mm diameter and 75mm long  and clamped
 > at 10mm spacing. Basically the advice is two to three  minutes per
 > 250ml of water or 40 to 60 minutes per 250ml for  distilled water.
 > 1 teaspoon  per  day  up to 3 tablespoons,  three  times  per day,
 > depending on  circumstances. That is max of 135ml  per  day (about
 > 1/2 a cup). 1/3 to 1/2 the dose to babies or children.

 > Is it  dose related? I have taken CS as drinking water  for  a few
 > days, (2  to  3  litre per day on a desert  hiking  trip)  with no
 > remarkable effects. Is it related to the water treatment?

 > I would really like to know.

 > regards,
 > Tony

 Hi Tony,

 Silver electrolysis should only be done with pure distilled water.

 For plain water, and assuming your constant current source goes into
 full limiting as soon as current is applied, a current of 1mA  for 3
 minutes  in   250ml   will   liberate   1.609ppm   of   silver ions.
 (Calculations provided at the end.)

 This is an insignificant amount of silver, and most of the ions will
 probably combine with various contaminants in the water.

 If you  are  relying  on this  to  protect  you  against water-borne
 disease, I'd  recommend boiling, or any of the other  proven methods
 for purifying water.

 It is  not possible to calculate the amount of  silver  liberated in
 your distilled  water example, since the voltage across the  cell is
 too low.  The initial resistance of the dw will allow  only  a small
 current to  flow.  The  current  will build  up  slowly,  but  it is
 doubtful the  current limiter will go into full limiting  during the
 brew cycle.

 Since we  do not know the average current, we  cannot  calculate the
 amount of silver liberated.

Best Regards,

Mike Monett

 --------------------------------------------------------------------

 The following uses Roger Schafly's Mercury Solver, available at

 http://archives.math.utk.edu/software/msdos/calculus/mrcry209/.html

 Conversion Factors
 ~~~~~~~~~~~~~~~~~~
 Coulombs     = I * Seconds            ; total number of Coulombs
 CoulombsGram = 107.868 / 96485        ; Coulombs per gram of silver
 Grams        = CoulombsGram * I * Seconds ; Faraday's equation
 Litres       = Millilitres / 1000     ; convert millilitres to litres
 Milligrams   = Grams * 1000           ; convert grams to milligrams
 ppm          = Milligrams / Litres    ; 1 ppm is 1 milligram per litre
 Seconds      = Hours * 3600 + Minutes * 60 ; get seconds

 Parameters
 ~~~~~~~~~~
 I           = 1e-3 ; current in Amperes
 Minutes     = 3 ; minutes
 Millilitres = 250

 Results
 ~~~~~~~
 Coulombs     = 0.360
 Litres       = 0.250
 Milligrams   = 0.402
 Millilitres  = 250.0
 Minutes      = 3.000
 ppm          = 1.609


--
The Silver List is a moderated forum for discussing Colloidal Silver.

Instructions for unsubscribing are posted at: http://silverlist.org

To post, address your message to: [email protected]
Silver List archive: http://escribe.com/health/thesilverlist/index.html

Address Off-Topic messages to: [email protected]
OT Archive: http://escribe.com/health/silverofftopiclist/index.html

List maintainer: Mike Devour <[email protected]>









--
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.6.11 - Release Date: 1/12/2005




--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.6.11 - Release Date: 1/12/2005




No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.6.11 - Release Date: 1/12/2005


--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.6.11 - Release Date: 1/12/2005




No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.6.12 - Release Date: 1/14/2005


--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.6.12 - Release Date: 1/14/2005