i use arrowhead distilled water, usually. $1.49/gal. k-mart had
distilled, on sale, so i tried a couple of gallons, and it was as good
as the arrowhead, so i switched. this lasted about 4 months, till i
bought 2 cases. first gallon out of that batch was terrible. they must
have changed suppliers, and the cs turned cloudy. went back to
arrowhead, but tried k-mart again after a few months. it is again very
good. i now test the water at the beginning of each batch with a "harbor
freight" multi-meter, with good distilled water reading about 0.17 to
0.20 ma, and brew till 1.40 ma.
jim
Ana Johnson wrote:
I have only been making colloidal for about 3 months and have always
had my batches be very clear but today I used the same brand
of distilled water, the same silver strands, plugged my generator in
for 3 hours. I did not check on it during the brewing time but when
the timer went off I ended up with a very cloudy batch that had
chucks in it.
I will not be ingesting this batch but can someone please respond
and tell me possibly what happened. I think my distilled water was
probably no good. Hope it was okay for drinking because I drank most
of this gallon. Can any harm be done to the silver strands since I let
the generator run for three hours??? It has a green light on the front
that should not glow when it is in use and it was really glowing when
I unplugged the unit. The instructions say that it will glow due to
mineral content in water but I am 100% sure I used distilled water.
Thanks for any info!!!!!!! Ana
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: silver-list@eskimo.com
Address Off-Topic messages to: silver-off-topic-l...@eskimo.com
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <mdev...@eskimo.com>
