I am a stupid woman that would love to have this, but i don't have the
knowledge to do this can you all help me?
----- Original Message -----
From: "Marshall Dudley" <mdud...@king-cart.com>
To: <silver-list@eskimo.com>
Sent: Monday, November 20, 2006 11:17 AM
Subject: Re: CS> Silver injector sketch notes
Another possibility would be to start with a whole house filter. Since the
chamber screws on an off, it would make it fairly easy to check the
electrodes. Or use a large fuel filter, similar design, but they have a
clear plastic housing so you can monitor without even unscrewing it.
Marshall
M. G. Devour wrote:
Adding a couple of comments...
To add a window, you might replace the cap with a piece of 1/4" plexiglas
acrylic sheet. It will bond with PVC cement just fine, I believe. To make
it more secure, use a coupling for joining two pieces of pipe and cut the
window to fit in the open socket, instead of just doing a butt joint
directly to the end of the pipe.
You'll probably want to move the inlet and outlet fittings to the side of
the pipe. That will keep you from having to put them through the window,
which would weaken it, or the cleanout plug, which you has to be removed
using a wrench or pliers to remove for service.
[Mike Devour, Citizen, Patriot, Libertarian]
[mdev...@eskimo.com ]
[Speaking only for myself... ]
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: silver-list@eskimo.com
Address Off-Topic messages to: silver-off-topic-l...@eskimo.com
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <mdev...@eskimo.com>