I have OpenVMS VAX 7.3 running in SimH on my Windows laptop, and I am trying to use networking using the WiFi on the laptop. However, I am getting an IP address of 0.0.0.0/8 in OpenVMS and obviously this is not the IP range I use at home (it is 172.16.6.0/24). Below is my current vax.ini so I don't have to type all the commands every time. Does anyone see anything with it that could cause the problem I'm seeing?
; ; Load CPU microcode load -r C:\Users\smccl\Downloads\simh\ka655x.bin ; ; Attach non-volatile RAM to a file attach nvr C:\Users\smccl\Downloads\simh\vaxdata\nvram.bin ; ; This virtual machine has 64M memory set cpu 512m ; ; Define disk drive types. RA92 is largest-supported VAX drive. set rq0 ra92 set rq1 ra92 set rq2 ra92 set rq3 cdrom ; ; Attach defined drives to local files attach rq0 C:\Users\smccl\Downloads\simh\vaxdata\d0.dsk attach rq1 C:\Users\smccl\Downloads\simh\vaxdata\d1.dsk attach rq2 C:\Users\smccl\Downloads\simh\vaxdata\d2.dsk ; ; Attach the CD-ROM to its file (read-only) attach -r rq3 C:\Users\smccl\Downloads\simh\vaxdata\cd.iso ; ; Disable unused devices. It's also possible to disable individual devices, ; using a construction like "set rq2 disable" if desired. ; set rl disable set ts disable ; ; Attach Ethernet to a network interface set xq mac=00:00:01:00:00:01 attach xq eth1 ; ; Uncomment the line below to enable auto-boot dep bdr 0 ; ; Choose one of the following lines. SET CPU CONHALT returns control to the ; VAX console monitor on a halt event (where behavior will be further ; determined by whether auto-boot is set--see above. SET CPU SIMHALT will ; cause the simulator to get control instead. set cpu conhalt ;set cpu simhalt ; ; Now start the emulator boot cpu ; ; Exit the simulator exit Shaun McCloud, MCDST
_______________________________________________ Simh mailing list Simh@trailing-edge.com http://mailman.trailing-edge.com/mailman/listinfo/simh