On Thursday, September 20, 2018 at 8:23 AM, Gregg Levine wrote: > Hello! > I grabbed the sources from GIT earlier today. And promptly built the two I'll > need. PDP11 for one, and the VAX ones for the other on a Raspberry Pi3. I even > added the options for networking that the README wanted. > > So running PDP11 I then saw this happen, and the VAX as well: > pi@raspberrypi:~ $ /home/pi/emul/simh/BIN/pdp11 > > PDP-11 simulator V4.0-0 Current git commit id: 49cfac90 > sim> show cpu > CPU 11/73, NOCIS, autoconfiguration enabled, idle disabled > 256KB > sim> exit > Goodbye > pi@raspberrypi:~ $ /home/pi/emul/simh/BIN/vax > > MicroVAX 3900 simulator V4.0-0 Current git commit id: 49cfac90 > sim> show cpu > CPU idle disabled, model=VAXServer 3900 (KA655), NOAUTOBOOT > 16MB, HALT to SIMH > sim> exit > Goodbye > pi@raspberrypi:~ $ > > It shows idle disabled. Okay how do I enable it on both? I haven't decided on > a > target for them but given that networking on SIMH works best connected to a > fixed source....... Anyway I remembered that any commentary here would > need to show those first two lines.
You do know that idling starts disabled, right. You have to explicitly enable it with a SET CPU IDLE command. There are certain conditions when the SET CPU IDLE won't work. Presuming SET CPU IDLE doesn't work, I could give a better answer if you provided: 1) the output of SHOW VERSION at the sim> prompt 2) the output produced by make when you built one of these simulators. and optionally: 3) The configuration file(s) you're using. - Mark _______________________________________________ Simh mailing list [email protected] http://mailman.trailing-edge.com/mailman/listinfo/simh
