Hello! I confess I didn't know that. And given what happens next regarding the PDP11 one, I shall certainly do all of that, if something does not work. For option 2 I didn't bother to save the output shown when making it, so I'll do that again, and save it to a text file.
For SHOW VERSION, shouldn't it be the same as what's shown in my selection? ----- Gregg C Levine [email protected] "This signature fought the Time Wars, time and again." On Thu, Sep 20, 2018 at 11:39 AM, Mark Pizzolato <[email protected]> wrote: > On Thursday, September 20, 2018 at 8:23 AM, Gregg Levine wrote: >> Hello! >> I grabbed the sources from GIT earlier today. And promptly built the two I'll >> need. PDP11 for one, and the VAX ones for the other on a Raspberry Pi3. I >> even >> added the options for networking that the README wanted. >> >> So running PDP11 I then saw this happen, and the VAX as well: >> pi@raspberrypi:~ $ /home/pi/emul/simh/BIN/pdp11 >> >> PDP-11 simulator V4.0-0 Current git commit id: 49cfac90 >> sim> show cpu >> CPU 11/73, NOCIS, autoconfiguration enabled, idle disabled >> 256KB >> sim> exit >> Goodbye >> pi@raspberrypi:~ $ /home/pi/emul/simh/BIN/vax >> >> MicroVAX 3900 simulator V4.0-0 Current git commit id: 49cfac90 >> sim> show cpu >> CPU idle disabled, model=VAXServer 3900 (KA655), NOAUTOBOOT >> 16MB, HALT to SIMH >> sim> exit >> Goodbye >> pi@raspberrypi:~ $ >> >> It shows idle disabled. Okay how do I enable it on both? I haven't decided >> on a >> target for them but given that networking on SIMH works best connected to a >> fixed source....... Anyway I remembered that any commentary here would >> need to show those first two lines. > > You do know that idling starts disabled, right. You have to explicitly > enable it > with a SET CPU IDLE command. There are certain conditions when the > SET CPU IDLE won't work. > > Presuming SET CPU IDLE doesn't work, I could give a better answer if you > provided: > 1) the output of SHOW VERSION at the sim> prompt > 2) the output produced by make when you built one of these simulators. > and optionally: > 3) The configuration file(s) you're using. > > - Mark _______________________________________________ Simh mailing list [email protected] http://mailman.trailing-edge.com/mailman/listinfo/simh
