there were no changes to paging for 4.4 so i'd bet it's the same
On Wed, May 18, 2011 at 5:55 PM, Matthew Kitchin (public/usenet) <mkitchin.pub...@gmail.com> wrote: > Old thread, but still relevant to me at least. > Does anyone have any updated info on paging limits within 4.4? Does the > info below still seem accurate? I'm chasing down some issues and I'm not > sure if I've run into this as well. My group had 17 in it, but I've got > it down to 14 by removing some phones that are near each other. Since > the pager doesn't get the page, there are 13 actual destinations on most > pages. > > On 11/24/2009 5:10 PM, Josh Patten wrote: >> Searching from April 2009 to present in the sipx-users list didn't >> reveal any paging server information. I was trying to avoid the expense >> of installing overhead paging equipment, but if it's necessary I will. >> As far as bandwidth goes, generously assuming 100 kbps x 200 extensions, >> that's approximately 20 megabits per second, FAR below the gigabit fiber >> I will be using. If anything it will be a limitation of the sipX paging >> module which as far as I know is limited by CPU speed and RAM, which I >> have plenty of. >> >> I gleaned most of my information from this page: >> http://sipx-wiki.calivia.com/index.php/Functional_Specification_for_a_Paging_Server >> which is a bit old so may be disconnected from reality. >> >> If anyone has actually tested this I'd be glad to know. >> >> Josh Patten >> Assistant Network Administrator >> Brazos County IT Dept. >> >> >> >> >> Todd Hodgen wrote: >>> There was discussion around this on the list a few months ago, and the >>> technical details were provided by one of the developers. There is a limit, >>> I don't recall what it is, but it wasn't as high as you are wanting to go >>> from what I do recall, but it was higher than 12. I'd check in the old >>> archives from the May/June timeframe or there about. >>> >>> -----Original Message----- >>> From: sipx-users-boun...@list.sipfoundry.org >>> [mailto:sipx-users-boun...@list.sipfoundry.org] On Behalf Of Josh Patten >>> Sent: Tuesday, November 24, 2009 2:02 PM >>> To: sipx-users@list.sipfoundry.org >>> Subject: [sipx-users] Paging server performance >>> >>> Has anyone documented or tested the performance of the paging server? >>> The reason I ask is because I am about to do a 200 phone rollout where, >>> occasionally, 100 phones will need to be paged at a time. On rare >>> occasions all 200 will need to be paged I have a pretty beefy server (8 >>> xeon 5500 series cores @ 2.33 GHz each, 16 GB RAM for primary proxy, >>> quad-core xeon 5500 2.33 GHz with 2 GB RAM for auxiliary redundant >>> proxy) and gigabit fiber to the location. Should I be concerned about >>> the performance of the paging server? >>> >>> >> _______________________________________________ >> sipx-users mailing list sipx-users@list.sipfoundry.org >> List Archive: http://list.sipfoundry.org/archive/sipx-users >> Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users >> sipXecs IP PBX -- http://www.sipfoundry.org/ > > _______________________________________________ > sipx-users mailing list > sipx-users@list.sipfoundry.org > List Archive: http://list.sipfoundry.org/archive/sipx-users/ > _______________________________________________ sipx-users mailing list sipx-users@list.sipfoundry.org List Archive: http://list.sipfoundry.org/archive/sipx-users/