line 124 is remmed out as i only have one line where I am currently and will need it back when I config for the office this will end up in tonight.
The caller id statements in the Port area, lines 171 and 179 gave me "Keyword mismatch errors" so i remmed them and copied them to lines 99 and 109 where I don't receive any errors. The line does receive caller I'd. There is an analog phone connect to this line at the same time while I test this. I made very few changes to the config mentioned previously in the post. I tend to rem before remove. -Bryan Anderson On Sat, May 5, 2012 at 5:53 PM, Tony Graziano <tgrazi...@myitdepartment.net>wrote: > You have no statements (or conflicting statements) regarding callerid. > > Why is it remmed out and also set to ring number two? Connect a analog > phone and determine if callerid is sent. > > On May 5, 2012 8:31 PM, "Bryan Anderson" <branderso...@msn.com> wrote: > >> ---------- Forwarded message ---------- >> From: "Bryan Anderson" <shadow...@gmail.com> >> Date: May 5, 2012 3:37 PM >> Subject: Re: [sipx-users] Patton Config from wiki >> To: "Discussion list for users of sipXecs software" < >> sipx-users@list.sipfoundry.org> >> >> Ok, so I have the latest 6.1 on. I have attached my configuration. Out >> going is working but not incoming. The gateway is not answering the calls. >> >> >> -Bryan Anderson >> >> >> >> >> On Sat, May 5, 2012 at 4:23 AM, Tony Graziano < >> tgrazi...@myitdepartment.net> wrote: >> >>> You should put the latest version 6.1 on it. >>> On May 5, 2012 1:31 AM, "Bryan Anderson" <branderso...@msn.com> wrote: >>> >>>> R5.2 >>>> >>>> I had gotten it to where some times it would call out. Now I dial the >>>> number, get a dial tone, then silence, then dial tone, then busy tone. >>>> >>>> -Bryan Anderson >>>> >>>> >>>> >>>> >>>> On Fri, May 4, 2012 at 7:05 PM, Tony Graziano < >>>> tgrazi...@myitdepartment.net> wrote: >>>> >>>>> What firmware version? >>>>> On May 4, 2012 5:50 PM, "Bryan Anderson" <branderso...@msn.com> wrote: >>>>> >>>>>> I have just received our two new Patton SN5420 4 FXO gateways. I >>>>>> pulled down the tested config from here: >>>>>> http://wiki.sipfoundry.org/display/sipXecs/Patton+4524+-+TESTED >>>>>> >>>>>> set the variables mentioned at the top of the page and removed the >>>>>> two FXS port listing at the bottom of the config. Now I am getting boot >>>>>> errors on reading the following four lines of the config. Please advise. >>>>>> >>>>>> context cs switch >>>>>> >>>>>> profile ringing-cadence default >>>>>> play 1 1000 >>>>>> pause 2 4000 >>>>>> >>>>>> >>>>>> >>>>>> -Bryan Anderson >>>>>> >>>>>> >>>>>> >>>>>> _______________________________________________ >>>>>> sipx-users mailing list >>>>>> sipx-users@list.sipfoundry.org >>>>>> List Archive: http://list.sipfoundry.org/archive/sipx-users/ >>>>>> >>>>> >>>>> LAN/Telephony/Security and Control Systems Helpdesk: >>>>> Telephone: 434.984.8426 >>>>> sip: >>>>> helpdesk@voice.myitdepartment.**net<helpd...@voice.myitdepartment.net> >>>>> >>>>> Helpdesk Customers: >>>>> http://myhelp.myitdepartment.**net<http://myhelp.myitdepartment.net> >>>>> Blog: http://blog.myitdepartment.net >>>>> >>>>> _______________________________________________ >>>>> sipx-users mailing list >>>>> sipx-users@list.sipfoundry.org >>>>> List Archive: http://list.sipfoundry.org/archive/sipx-users/ >>>>> >>>> >>>> >>>> _______________________________________________ >>>> sipx-users mailing list >>>> sipx-users@list.sipfoundry.org >>>> List Archive: http://list.sipfoundry.org/archive/sipx-users/ >>>> >>> >>> LAN/Telephony/Security and Control Systems Helpdesk: >>> Telephone: 434.984.8426 >>> sip: helpdesk@voice.myitdepartment.**net<helpd...@voice.myitdepartment.net> >>> >>> Helpdesk Customers: >>> http://myhelp.myitdepartment.**net<http://myhelp.myitdepartment.net> >>> Blog: http://blog.myitdepartment.net >>> >>> _______________________________________________ >>> sipx-users mailing list >>> sipx-users@list.sipfoundry.org >>> List Archive: http://list.sipfoundry.org/archive/sipx-users/ >>> >> >> >> _______________________________________________ >> sipx-users mailing list >> sipx-users@list.sipfoundry.org >> List Archive: http://list.sipfoundry.org/archive/sipx-users/ >> > > LAN/Telephony/Security and Control Systems Helpdesk: > Telephone: 434.984.8426 > sip: helpdesk@voice.myitdepartment.**net<helpd...@voice.myitdepartment.net> > > Helpdesk Customers: > http://myhelp.myitdepartment.**net<http://myhelp.myitdepartment.net> > Blog: http://blog.myitdepartment.net > > _______________________________________________ > sipx-users mailing list > sipx-users@list.sipfoundry.org > List Archive: http://list.sipfoundry.org/archive/sipx-users/ >
_______________________________________________ sipx-users mailing list sipx-users@list.sipfoundry.org List Archive: http://list.sipfoundry.org/archive/sipx-users/