Sounds like many things: Logging in as user instead of admin Primary port not set right Wrong FW for repeater mode Wrong MAC in authentication on main AP Water in cable Bad power (low voltage) Faulty powerShot Wrong config on xxxxxxx(fill in the blank)
Have you used simpleDeploy on it, what FW are you using, what version of NMS or simpleMonitor are you using, how much cable are you using, can your test device see the main AP and the repeater AP, what model of power supply are you using, how old is the unit, are you plugging anything in to the Ethernet port of the router, where are you monitoring it from, if you 'factory default' the repeater AP how is it staying in repeater mode, what IPs and subnet are you using, how far is the repeater from the main AP, how far is the monitoring device away from the repeater, how far away is the monitoring device away from the main AP, how much wireless experience do you have, how much networking experience do you have? Unless someone has had this EXACT problem and fixed it, we just don't have enough information to troubleshoot the problem. Please give more detail. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Shawn Mitchell Sent: Tuesday, June 17, 2003 1:09 AM To: [EMAIL PROTECTED] Subject: [smartBridges] Wireless port problems... Ok... Here's a big problem that's starting to just p*** me off... airPoint Pro (indoor) Unit 1: Will not do any RF Output when in repeater mode... If I set it to AP mode, and reset it (holding in the reset button) and clicking the factory default's button... and spend 10 min or so doing this the unit will start sending RF packets... Now, the counters show that it's getting rf packets, but not a single tx packet... not even beacon's... Now, Unit 2: Same problems as Unit one, except with a twist... On the Tx packets for the RF interface, I see one broadcast... never anymore than that... and the Ethernet interface keeps resetting about every 2 min... This one is just going to be a normal AP... Has anyone ever seen anything like this before? On Unit 1 I'm trying to Associate it to an AP. I can see many AP's, but any of them I double click on it just counts down to 0 seconds and gives me the failed message. If I put the info (ESSID, BSSID, etc) in manually, as soon as I hit the Set Values button, it pop's up an error telling me it can't set it... Any idea's? Or do I have to RMA these units? I already have a handful of other ap's that I am having to rma... The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://198.63.203.6 The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://198.63.203.6
