�����������
����������� Yes, our next generation products definitely will
have those features but now may not be possible.
����������� Seeni, SB support
-----Original Message-----
From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of phantam
Sent: Friday, June
27, 2003 9:25 AM
To: '[EMAIL PROTECTED]'
Subject: RE: [smartBridges]
airPoint-PRO and VLAN
Seeni are there any chances of adding vlan tagging or
basic port blocking on the current APPO's ( I mean they are PRO units :) and
the nexus are so far off ) Would really appreciate a straight answer thanks.
Chris
-----Original Message-----
From: Seeni [mailto:[EMAIL PROTECTED]]
Sent: Thursday, June 26, 2003 1:48
PM
To: [EMAIL PROTECTED]
Hi J a k o b B o r g,
AirPoint PRO does support VLAN
tagging thru PtP mode, by allowing "non
IP
traffic" option in the
Advanced TAB. Before you test point to point
wireless bridge mode, please make
sure that Access point - CB mode
combination works first and then
switch into the wireless bridge mode.
In point to point mode, please
configure the PRIMARY PORT
correctly and it enables to reach
the default gateway of the
network.
To illustrate an example,
Router/PC1 ----Switch 1
------AP1(ptp)---------AP2(ptp) -------Switch
2-----PC2
In the above setup, the AP1 primary port will be set
to Ethernet and AP2
is set to Wireless, the direction
is based on where the router is. Also
ensure the configuration port is
set to Ethernet & Wireless for both
units.
Please test using latest
simplemonitor 1.5 with firmware 1.4j.6.
I hope above info helps. Thanks
Seeni, SB support
-----Original Message-----
From:
[EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]
On Behalf Of Jakob Borg
Sent: Thursday, June 26, 2003 9:15
PM
To: '[EMAIL PROTECTED]'
Subject: [smartBridges]
airPoint-PRO and VLAN
Hi all,
I'm new to this list and couldn't find an archive to
browse, so please
forgive me if what I bring up has
already been discussed to death. I
just have a very simple question
that doesn't seem to be answered by the
documentation, namely whether or
not you can transmit VLAN
(802.1q)-tagged
frames over a link consisting of
two airPoint PRO modules in wireless
bridge mode.
Hints appreciated.
Regards,
--
J a k o b B o r g
/ Lunds Stadsn�t AB /
http://www.lundsstadsnat.se/
[EMAIL PROTECTED]
/ +46 (0)46 2863373 / +46 (0)70 6466677
The PART-15.ORG smartBridges
Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body
type subscribe
smartBridges <yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body
type unsubscribe
smartBridges)
Archives: http://archives.part-15.org
The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body
type subscribe smartBridges <yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body
type unsubscribe smartBridges)
Archives: http://archives.part-15.org
