Title: Message
|
I have tried locking everything to 11 with the same
results.
----- Original Message -----
Sent: Wednesday, July 02, 2003 6:24
AM
Subject: RE: [smartBridges] Having
throughput issues with APPO
Also, be sure to set
the rate to 11 Mbs with auto fallback on. I know I get 300K when I set
the radios to 1 or 2 Mbs.
-----Original
Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On
Behalf Of Ray
Sent: Wednesday, July 02, 2003 8:55
AM
To: [EMAIL PROTECTED]
Subject: Re: [smartBridges] Having
throughput issues with APPO
I have swapped the switch out for
an old hub (10M only) and used a cross over cable but still have the same
problem. There are no LOS issues.
----- Original Message -----
Sent:
Tuesday, July 01, 2003 11:06 PM
Subject: RE:
[smartBridges] Having throughput issues with APPO
Are
you relying on the switches auto-crossover function (if it has it). Make
sure that all radios have Basic Rates set to All or 11Mb with Auto Fall Back
enabled. If you are too close to the make sure the link can support 11Mb. If
you are too close or too far or poor LOS you will only get lower
speeds.
-----Original
Message-----
From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
On Behalf Of Ray
Sent: Tuesday, July 01, 2003 2:35
PM
To:
[EMAIL PROTECTED]
Subject: [smartBridges] Having
throughput issues with APPO
Our wiPoP is having throughput
issues. We have it plugged into a switch that has our backhaul APPO
plugged in. We can plug a laptop into the switch and pull 4 megs all
day. But when we associate with the wiPoP we can only get 1 meg
(total).
We have 150 feet of cat 5 and
we're using an 18v power supply. RSSI and LQ is 100%. I can
start a download (internal) and get 1-meg and on a second client (different
ABO) start a download and both drop to 500k.
Does anyone have any ideas
regarding this?
|
