> > I have the following problem: > > I have setup two airpoint pro outdoor one in AP mode and > the other one > > in client bridge. > >>From the client bridge I can download (receive from the AP) > at speeds > >>of > > 300-400kb/sec but I can send only at 50-80kb/sec. > > What antennas do you use ?
I use MaxRad 13dbi directional panels on both APs > Have you checked the spectrum in both directions ? what's > your noise floor ? antenna aligmnet ? I'm sorry but you are getting too technical for me. How do I get the noise floor? How do I check the spectrum? I see from the AP (the client bridge always give me higher numbers) that RSSI is 95% (-14 dBm) and link quality goes between 75% and 95%. The antennas (D-pads) are aligned to each other quite roughly. The link worked so I though I will leave them as is. > A simple test is to swap just the units and try to > upload/download again. That will help trouble shooting. This is not very easy as the AP is on a 4m high pole and needs a lot of work to take it down. I can do whatever I want on the client bridge cause it is much more easier accesible. Thanks, Spyros The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
