Ooh.. I thought you meant the actual plug... the barrel connector that fits into the airbridge. I normally cut it off the 12 volt one that's supplied and solder it onto an 18v supply when needed.
----- Original Message ----- From: "Sam" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Wednesday, August 06, 2003 9:23 AM Subject: Re: [smartBridges] AirPoint-Pro Outdoor > I have never received an 18 volt powershot with any of the units I have > purchased. They are all 12 volt. > > On Wed, 6 Aug 2003, Roger Howard wrote: > > > They do.. you get one with every unit :) > > > > ----- Original Message ----- > > From: "Sam" <[EMAIL PROTECTED]> > > To: <[EMAIL PROTECTED]> > > Sent: Wednesday, August 06, 2003 9:12 AM > > Subject: RE: [smartBridges] AirPoint-Pro Outdoor > > > > > > > Seeni > > > > > > Why doesn't Smartbridges make these plugs available? > > > > > > Sam > > > > > > On Wed, 6 Aug 2003, sBTech wrote: > > > > > > > Hi Rob Cleminson, > > > > > > > > > > > > > > > > An 18 V DC plug is an ideal and sufficient plug however you have to make > > > > sure that the polarity of the plug should as specified in the website. > > > > > > > > http://www.smartbridges.com/new/products/ps.php > > > > > > > > > > > > > > > > Few customers are using Motorola Canopy Powershot which is 24V and it is > > > > same pin as sB. > > > > > > > > Also you can use the following powersupply, however you need to change > > > > the Pin polarity as stated in the specification. > > > > > > > > Brand: Mouser > > > > > > > > Model: 552-PSA-31U-180 [EMAIL PROTECTED] > > > > > > > > > > > > > > > > To help you procure the correct power supply adapter, the specification > > > > of the power adapter is :- > > > > > > > > > > > > Output Voltage Range > > > > > > > > Regulated between 15V to 18V (max) > > > > > > > > > > > > Current Ratings > > > > > > > > 1 Ampere > > > > > > > > > > > > Type of Plug > > > > > > > > Barrel Type > > > > > > > > > > > > Plug Polarity > > > > > > > > outer body = +ve, center = -ve > > > > > > > > > > > > > > > > Diameter of plug > > > > > > > > Inner Diameter of the plug = 2.5mm > > > > Outer Diameter of the plug = 5.5mm > > > > > > > > > > > > Length of the plug > > > > > > > > 10mm or more > > > > > > > > > > > > > > > > Thank you > > > > > > > > > > > > > > > > Seeni, SB support > > > > > > > > > > > > > > > > -----Original Message----- > > > > From: [EMAIL PROTECTED] > > > > [mailto:[EMAIL PROTECTED] On Behalf Of Rob Cleminson > > > > Sent: Wednesday, August 06, 2003 12:57 AM > > > > To: '[EMAIL PROTECTED]' > > > > Subject: [smartBridges] AirPoint-Pro Outdoor > > > > > > > > > > > > > > > > Hi, > > > > > > > > > > > > > > > > I just purchased my first Airpoint Pro Outdoor - Powered it up fine on > > > > my desk. > > > > > > > > > > > > > > > > Just got down from installing on my tower - I have 100Metres of CAT5 and > > > > now no power is arriving at the unit? > > > > > > > > > > > > > > > > Is this because I am using the standard 12V AC Adapter and because of > > > > the extra cable length now need 15V. There is a note in the booklet > > > > suggesting that this is best but I am not sure if it is a MUST > > > > > > > > > > > > > > > > Any advice? > > > > > > > > > > > > > > > > Regards > > > > > > > > > > > > > > > > Rob Cleminson > > > > > > > > > > > > > > > > > > > > > > The PART-15.ORG smartBridges Discussion List > > > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > > smartBridges <yournickname> > > > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > > smartBridges) > > > Archives: http://archives.part-15.org > > > > The PART-15.ORG smartBridges Discussion List > > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> > > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) > > Archives: http://archives.part-15.org > > > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) > Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
