I would say it's a power issue over anything else. I guess it wouldn't hurt to put new RJ45 ends on to see if that fixes your problem before you go by the power supply. But 100 meters is just to far for 12V
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Rob Cleminson Sent: Tuesday, August 05, 2003 11:11 AM To: [EMAIL PROTECTED] Subject: RE: [smartBridges] AirPoint-Pro Outdoor I can shorten the cable a bit if necessary but just want to see power up there for now - Is 18V a MUST or could there be something else wrong? Cheers Rob -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Sam Sent: 05 August 2003 18:07 To: [EMAIL PROTECTED] Subject: RE: [smartBridges] AirPoint-Pro Outdoor Make sure if you get one at Radio Shack that it outputs DC voltage and not AC. I bought one there without paying attention, and it was VAC. Also you'll need to buy an adaptor to make sure it will fit into the powershot. (You should probably take the powershot with you to the store.) On Tue, 5 Aug 2003, Coy Wadsworth wrote: > Correct me if I'm wrong but that is like 328 Feet. You should only run > CAT5 300 feet at the most and that's when your not running power over > Ethernet. I would look for a 18V power supply. I think you can purchse > them at radio shack. > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Rob Cleminson > Sent: Tuesday, August 05, 2003 10:57 AM > To: [EMAIL PROTECTED] > Subject: [smartBridges] AirPoint-Pro Outdoor > > Hi, > > I just purchased my first Airpoint Pro Outdoor - Powered it up fine on > my desk. > > Just got down from installing on my tower - I have 100Metres of CAT5 and > now no power is arriving at the unit? > > Is this because I am using the standard 12V AC Adapter and because of > the extra cable length now need 15V. There is a note in the booklet > suggesting that this is best but I am not sure if it is a MUST > > Any advice? > > Regards > > Rob Cleminson > > The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
