I'm running some trials using an APPO, APPO Total and an ABO Total. The network set-up is as follows: APPO Total (Access Point mode & 192.168.16.30) --> APPO (Repeater mode & 192.168.16.25) --> ABO Total (Client & 192.168.16.60). There is one PC connected to each of the sB radios, with the PC connected to the APPO Total acting as a web server to simulate an Internet connection.
In this set-up, the PC connected to the ABO can ping the APPO Total, APPO and their respective PC's. However, the PC connected to the APPO - the 'Repeater' - cannot ping the other sB radios or their PC's. If the mode on the APPO is changed to 'Client Bridge', a reply is received from the other radios in their respective Ping window immediately. Set it back to 'Repeater' mode and the Ping times out. I understood that (quote sB literature) "In this Mode airPoint-PRO radio act as Access Point and Ethernet client simultaneously." However the client cannot do a lot - not even connect to other sB equipment! Has anyone got any suggestions as to why this is happening? I need the repeater mode to work to enable any 'nodes' I can use to redistribute the signal to have a single radio which acts as and AP and client! Regards Andrew Watkins Granero Data Systems Bristol, UK The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
