The AP is a Cisco.. and I guess I can do that... Yep, one bad link can cause a mess since you are talking about 1/2 duplex.. I guess I should put up the second antenna on the AP 350 and use one for transmit and one for receive... that might help a bit, huh?
Scott ----- Original Message ----- From: "Geo_p15sb" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Wednesday, November 26, 2003 12:17 AM Subject: Re: [smartBridges] upload vs download > Not sure what the AP interface looks like in SB, but does it tell you > idle time, noise, signal, quality, and data rate? > When stuff has happened with one of my sectors, usually I can trace it > down to who's not idle and then look to see who's got the worse stats > and go from there. > Maybe this helps > George > > Dan Petermann wrote: > > > Take a close look at all of the other radios. 1 bad link will screw them > > all up. > > If you have to, take each radio off line, 1 at a time and test. If no > > change, then that > > 1 radio wasn't the problem. Put it back on line and try the next one. > > > > I haven't found Frag to do much on MY network, YMMV. RTS on the other > > hand has > > made rotten connections work great. Just today by changing RTS on a > > client to 1200 > > changed his download speeds from 380k to 1.2M. > > > > As much as I hate to say this, you are going to have to check all your > > links. See which ones > > are running great and which ones are sucking wind. Compare both ends of > > the radio link. > > > > I've worked on radio links for 20 years and all I can say it can be > > quite frustrating. Too bad that > > in this price range the troubleshooting tools are virtually nonexistent. > > 802.11b is a PITA to > > troubleshoot. > > > > > > On Tuesday, November 25, 2003, at 04:44 PM, Rudolph Worrell wrote: > > > >> I have seen this also in some cases so you are not alone. Anyone with a > >> clue as to what is happening here? > >> > >> -----Original Message----- > >> From: [EMAIL PROTECTED] > >> [mailto:[EMAIL PROTECTED] Behalf Of shoffman > >> Sent: Tuesday, November 25, 2003 6:43 PM > >> To: [EMAIL PROTECTED]; [EMAIL PROTECTED] > >> Subject: [smartBridges] upload vs download > >> > >> > >> Hi all, > >> > >> Know this has been discussed several times.. hate to repeat an old > >> topic. > >> > >> Here is scenario: > >> > >> Customer has ABTotal. RSSI 75%, Link quality 95% on its reading. Long > >> Preamble, 5 MBps auto (also tried at 11 Mbps auto). > >> > >> Frag set at two different levels: 512 and 2336 (off) > >> RTS set at two different levels (4combos in all): 128 and 2337 (off) > >> > >> Ethernet card at 10 - 1/2 duplex > >> > >> AP is Cisco 350 - RTS Off, Frag 2336. Signal Strength at 50%. > >> > >> In all cases: Download 600-800 kbps, upload (best with RTS off) 36 kbps, > >> with RTS 8 kbps. > >> > >> Network has RTS on all other devices pointed at that AP at 128. > >> > >> So... thoughts? We are going to re-terminate...go with an outdoor and > >> parabolic.. But is this interfernce? SB device see no other signal, > >> have not sent out an SA yet. All other clients are doing pretty good on > >> this network. We will send an SA out to be sure, but still..... > >> > >> > >> Thoughts > >> > >> Scott > >> > >> The PART-15.ORG smartBridges Discussion List > >> To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > >> smartBridges <yournickname> > >> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > >> smartBridges) > >> Archives: http://archives.part-15.org > >> > >> The PART-15.ORG smartBridges Discussion List > >> To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > >> smartBridges <yournickname> > >> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > >> smartBridges) > >> Archives: http://archives.part-15.org > >> > > > > The PART-15.ORG smartBridges Discussion List > > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe > > smartBridges <yournickname> > > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe > > smartBridges) > > Archives: http://archives.part-15.org > > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) > Archives: http://archives.part-15.org > The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
