At 10:42 AM 12/12/99 -0800, Steve Witt wrote:
>I'm building a DAW TG-3,
>...
>. I'm not sure which
>one of these servo arms to use on the servos.
You can either use the single arm or cut the 4-arm one single arm. Use the
arm that when the servo is at neutral it aligns to a right angle with your
control rod. That usually works the best.
Length of arm will vary depending on type and torque of servo. You can
adjust either ends of your linkage to get the throw necessary. Start with
the arm the same length as the control horn, then move the clevis or Z-bend
on the servo in closer to reduce throw or move the clevis in closer on the
control service horn to increase throw.
Steve Meyer http://www.mcs.net/~stmeyer/
[EMAIL PROTECTED]
S.O.A.R. in Gurnee, IL
S.O.A.R. Web Page http://www.mcs.net/~stmeyer/SOAR/
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED]