If everyone looked in their "old servos" box and listed what they have, it might make 
the point.  I looked and have 80's 81's, locked up 255's, Dads, several different CS 
servos, an assortment of Airtronics servos (4 141's that won't center right, some 
151's I just put new gears in and they are fine now, a couple 131's and some standard 
servos) and two Volz wing max (broken shafts) and I had some Critter Bit servos until 
Karlton said to send them to him.  I have sent several Hitec servos in and they were 
replaced at no charge.  Now... the last two years (and with some major crashes 
included) I have not had to replace one MPX servo.  I used to go through 141's like 
crazy.  I have Micro 3 BB's and FL's  and they just keep on ticking.

In the long run I could have been using the best mc/V2 servos and actually saved money.

Tom

"Jerry R. Craft" wrote:

> Use the HS-85MG, the nylon gears are too thin and
> will not take any abuse.
>
> ----- Original Message -----
> From: <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Cc: <[EMAIL PROTECTED]>
> Sent: Sunday, February 27, 2000 4:37 AM
> Subject: [RCSE] Re: Alternative Servos
>
> > Mark -
> > Sounds like you are on the right track here. I agree with your choices -
> with
> > 1 possible exception. I used the HS85's in the ailerons of a Sapphire
> wing,
> > and on a really hot zoom they would give up. The ailerons would flutter
> and
> > I'd have to swap out a gear set. No huge deal, I learned to slow down a
> > little. It should be noted that the ailerons on a Sapphire are huge, long,
> > and a little "springy" - factors that can all add to the problem.
> > What kind of plane are you putting these in?
> > happy trails - Rob
> >
> > <<  I ordered HS225BB's for aileron, elevator and rudder. HS225MG for
> flaps.
> >  Could save a bit of weight with HS85's for ailerons.
> >  Mark >>
> > RCSE-List facilities provided by Model Airplane News.  Send "subscribe"
> and "unsubscribe" requests to [EMAIL PROTECTED]
>
> RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
>"unsubscribe" requests to [EMAIL PROTECTED]

--
Tom Broeski -- Afton, VA

T&G Exhibits  (Exhibit and Prototype Design)
http://www.adesigner.com
T&G Hobbies  (Home of the "Quote")
http://www.adesigner.com/hobbies.htm
BRASS (Blue Ridge Area Soaring Society)
http://www.adesigner.com/brass.htm
BRIC  (Blue Ridge Inventors' Club)
http://www.inventorclub.org
540 943-3356


RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to