I have been flying one for a couple of months now and I would say that it is
a very capable flyer, but building it was not the easiest. 

 - The instruction manual is lacking in explanations (it only has step by
step drawings). 

 - If you are going to build the full house (no polyhedral) I would suggest
building each wing half as one entire piece - It makes construction much
easier.

 - I would also add a small dowel at the root of the wings (back near the
trailing edge) to act as a second connector which will keep the wings at the
same Angle of Attack (otherwise screwing down one wing more that the other
will result in twist).

 - I would move the rudder and elevator push rod tubes out to the edge of
the fuselage - this makes getting into the fuselage so much easier.

If I had it to do all over again - I would have bought the Spirit 100, which
is only a little more expense at Tower Hobbies, gives you a bigger ship, has
the wing ribs for both the sport and advanced wing included in the kit, and
has a much more user friendly instruction manual.

Hope this helps.
______________________
Matthew Kovacs
AMD Fab 14/15 Etch Engineering
5204 E. Ben White Blvd., M/S 540
Austin, Texas 78741
(512)602-2662

> -----Original Message-----
> From: Louis Cimon [SMTP:[EMAIL PROTECTED]]
> Sent: Monday, August 28, 2000 12:19 PM
> To:   RCSE
> Subject:      [RCSE] Spirit Elite
> 
> I am thinking about upgrading from my old
> Sophisticated Lady to a Spirit Elite. I have a
> Futaba 8 so programmable transmitter is no
> problem.
> 
> I would like to know comments about actual use of
> the Spirit Elite.
> 
> Thank you very much
> 
> -- 
> Louis Cimon                       
> [EMAIL PROTECTED]
> 141 rue Mistral                   
> www.mediom.qc.ca/~lcimon/planeur.htm
> Beauport, QC                      tel : (418)
> 664-1023
> Canada
> G1E 5V4
> RCSE-List facilities provided by Model Airplane News.  Send "subscribe"
> and "unsubscribe" requests to [EMAIL PROTECTED]
RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to