Greg Nuspel asks:

>I was looking at the process of cutting swept wing cores. It would be
>preferable to not have to put the core on the table at the swept angle. I
>would like to be able to calculate the airfoil coordinates required if the
>blank is cut with it laying parallel to the table edge.
>
>I have looked at calculating the different cord lengths which is easy but
>the actual airfoil points become quite complicated. Does any of the existing
>software handle this calculation?

You need to increase both the thickness AND the camber by 1/cos(sweep
angle). The program we use, Eric Sanders' CompuFoil (www.compufoil.com)
does this, and Chuck Anderson's program might do it as well. In CompuFoil,
just go to the "Modify" pull-down menu, and the "modify camber" and "modify
thickness" are the first two items on the menu.

However, you really don't need to bother with modifying the templates at
all. Just cut the core blank with the correct sweep on the root and tip
ends, make your templates match the finished chords, then nail the
templates to the ends of the core blank. Set the core blank on your foam
cutter with the trailing edge parallel to the edge of the cutter, just as
with an unswept panel. Yes, the wire will be sliding across the template at
an angle. As long as the template is smooth, reasonably stiff, and
adequately held against the end of the core, this will NOT be a problem.
I've cut MANY cores for swept wings this way with no trouble.


Don Stackhouse @ DJ Aerotech
[EMAIL PROTECTED]
http://www.djaerotech.com/
RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to