I have built a Terminator HLG with a balsa fuse from the plans at
www.charlesriverrc.com and covered the fuse with 3/4 oz. fiberglass and
water based urethane. I did not paint it and the glass went on easy. Looks
smooth and the glass adds some strength. Of course, I purposely shaped the
nose to reduce the compound-ness of the curves so it would cover easier.
You could probably skip the glass for a 3 meter ship and you can tint water
based urethane with food coloring.
Every other fuse I made was covered in monokote. Turn up the iron to
350-370 F, keep stretching it out, and be patient. It will mold to almost
any surface if you have the patience to do it.
Tom Koszuta
----- Original Message -----
From: "Nick P Wisdom" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, February 01, 2001 6:01 PM
Subject: [RCSE] Balsa Fuses: Paint or Cover?
> Working on a 3M scooter with a large balsa/ply fuse. I have always used
monocote or similar in the past, and I have never tried painting. What are
the pros and cons of painting vs monokote? I have a hell of a time covering
the nosecone and those pesky curves, so painting sounds attractive, but only
if I still get some added strength and a nice finish. Any suggestions?
>
> Thanks,
>
> Nick Wisdom
> Orlando, FL
>
>
> Get your small business started at Lycos Small Business at
http://www.lycos.com/business/mail.html
> RCSE-List facilities provided by Model Airplane News. Send "subscribe"
and "unsubscribe" requests to [EMAIL PROTECTED]
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED]