Rather simply actually. After creating an area for the wiper to reside
within the TE of the main wing, bend the control surface open so as to
apply a strip of electrical tape in such a manner so as it is positioned
to actually act as a wiper.
In other words, lay a portion of the tape on the control surface LE, and
allow the rest to bend underneath the TE of the main wing. Play with it
a bit to create a nice radius.
Now mix up some cabosil and epoxy. Bend the control surface back so that
you can apply this mixture to the LE of the control surface, and onto
the sticky side of the elctrical tape. Spread it in such a way as to
create a nice smooth layer from root to tip. Make sure to apply far
enough out onto the tape to make a wide enough wiper. Now, using a
straightedge (or something similar) to help re-position the tape to
slide under the TE of main wing. Re-position the control surface with
the tape sliding into the TE area of the wing. Set the control surface
upside
down so that the epoxy/cabosil mixture is being cradled by the
electrical tape. Deflect the control surface away from neutral enough so
as to create a nice radius on the soon-to-be wiper (the tape is what is
setting the curvature) as the mixture dries.
It is then a case of removing the electrical tape and trimming the LE of
the Wiper to suit the control surface throw. On flaps, you will need to
spread the mixture quite a ways onto the tape in order to get a long
enough wiper. Viola!
"David J. Schat" wrote:
>
> I didn't get any.... I must be blacklisted.
>
> Can you tell me more about your method?
>
> Thanks
>
> At 09:31 AM 6/11/01 -0700, you wrote:
> >Hi David,
> >
> >Did you get any replies on this post? I am also interested in learning how
> >others do wipers. I use the old fashioned method of gluing plastoc wipers
> >to the flap.
> >
> >Gavin
> >
> >-----Original Message-----
> >From: David J. Schat [mailto:[EMAIL PROTECTED]]
> >Sent: Saturday, June 09, 2001 10:19 AM
> >To: [EMAIL PROTECTED]
> >Subject: [RCSE] Wipers on molded wings.
> >
> >
> >Any info on how these are done? Pics, supplies etc.
> >
> > -Spud
> > -Never lick a steak knife.
> >
> >RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
> >"unsubscribe" requests to [EMAIL PROTECTED]
>
> RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
>"unsubscribe" requests to [EMAIL PROTECTED]
--
*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*
Simon Van Leeuwen, Calgary, Alberta
RADIUS SYSTEMS
Cogito-Ergo-Zoom
IAC25233*MAAC12835*IMAC1756*LSF5953*IMAA20209
*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*~*
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED]