Hi Tullio and the rest of RCSE, 

The joiner Barry was using was 1/2" square custom made joiner from Doug Boyd 
aka the Winch Doc. He is a master machinest and he will CnC mill dang near 
anything you need or want! 

The molded RnR plane that Barry was flying had a special (very expensive) DS 
lay up scheme when it was built. All I know is they used lots of carbon and 
doubled the joiner size. The plane is very stout and fast to boot! :-)

I think your best bet is to stick with pylon mounted 3 piece wings. They are 
easier to make stronger to withstand the flight loads that DS can produce.

If you are going to continue using 2 piece wings with a joiner then I 
recommend you find some joiners that are made of case hardened steel. This 
should eliminate the permenant bending you mentioned. Also you might consider 
building your planes to allow for 2 joiners instead of one.

If you would like to view a simular model to the one Barry was flying then 
visit RnR's website and have a peak at the Millennium.
http://www.rnrproducts.com/

Best,

Dave
www.reeseproductions.com

In a message dated 6/19/01 2:05:32 AM, [EMAIL PROTECTED] writes:

<< Hi, guys,
First of all congrats to the "guy", of course,  then , please, some more
info on the plane : here in Italy we are all "boiling". As Dave already
knows, I'm the one who, after having read on RCSE about DS by JW, was the
first in Italy to do it, more than 2 years ago.
Well we'd like to know more about the model and its structure, specially the
wing joiner.
We are all discovering that our single and even double 14 x 3 mm steel
blades ( the ones sold by Graupner, I believe) are actually bending
permanently after strong DS session, which are surely below your recorded
speed, so we are wondering about your "square" half inch one. Is it really a
square one or is it a blade ?
Does a picture of the model exist somewhere on the web ? or in Lift Ticket ?
How is the wing built ?

I thank you very much for the info and be known that we all envy you for the
ball you had !

Ciao from Italy.
Tullio.


Ing. Tullio BONFIGLIO
Ansaldo Energia
IMP/ING/AUT - F12 / P5
Via N. Lorenzi, 8
16152 Genoa  -  ITALY
Ph. : 39 (0)10 655 3267 >>

RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to